Gray Wire (Optional Trunk Release Output) - Omega Research & Development INSTALLATION MANUAL Installation Manual

The Optional DLS -3 And 2 Or 3 SPDT Relays - Driver Door Unlock Priority
The DLS-3 is a triple relay socket (three relays are also needed) and is the most universal
interface which allows the security system to lock the vehicle's doors, unlock only the driver's
upon disarming (driver's door unlock priority) and, if desired, a second press of the
transmitter's button within 5 seconds of disarming will unlock all of the doors. The DLS-
3 used with two relays can be used in place of the DLS to lock and unlock all doors.
Standard Doorlocks
Relay Relay
DLS-3
DLS-3 Violet
Wire To
DLS-3
DLS-3
Ground
Blue Wire
Green
To Door
Wire To
Unlock
Door Lock
W ire .
W ire .
Ground
D o o r
Lock
S w i t c h
Three Wire Negative Doorlock Systems With Optional
DLS-3 And Two Relays For Standard Doorlocks Or
Three Relays For Driver's Door Priority Unlock.
Doorlocks With Driver Door Unlock Priority
Driver's Doorlock
Actuator
Relay
Relay Relay
DLS-3
Blue
Gray V i o l e t
Brown
P in k
CUT HERE
Unlock
Green
Lock
V e h i c l e ' s
Doorlock
Doorlock
R e l a y C o n t r o l
Actuators
U n i t
Page - 36
to optional relay pin (85), and connect Constant Positive 12 Volts to relay pin (86). Con-
nect pins 87, 87a & 30 as indicated in the following typical diagram:
To Positive Or Negative As Needed. In
This Case, Negative Is Required. In Oth-
ers, Positive. In Some Applications The
Wire Will Rest At Ground. Cut The
Wire, Switch Side To Pin 87a, Solenoid
Side To Pin 30 and 12 Volts To Pin 87.
To 12 Volt
Positive
Release
Switch
Wiring An Optional Relay For Trunk Release.
Security
System
Gray Wire
Control
Unit
87
86 87a 85
Optional
30
Relay
Release
Solenoid
Page - 9
To 12 Volt
Positive