InFocus LP 425 LiteMount Installation Manual page 9

Hang the Projector on the Ceiling
1 Loosely install the 12 mm knurled knobs, flat
washers, and conical spacers to the 2 hinge
pins on the base box (Figure 4).
spacer
washer
knurled knob
slide projector
bracket here between
the base box and the spacer
Attach knurled knobs to the side of the base box
2 Make sure your cables are pulled through the
center hole of the base box, then carefully lift
the projector and turn it upside down so the
mounting plate faces the ceiling (Figure 5).
3 Insert the projector and mounting bracket
slots onto the base box hinge pins between
the spacers and base box (Figure 4). Slide the
projector bracket forward until the hinge pins
rest fully in the vertical slots and support the
projector.
F 4
IGURE
7