Basic Saw Operations; Body And Hand Position - Skil 3315 Operating/Safety Instructions Manual

SM 2610012178 07-10:2610007743 07-09 3315 7/8/10 1:55 PM Page 38

Basic Saw Operations

Body and Hand position

W RNING
the following instructions (Figure 19).
• Never place hands near cutting area. Keep hands
outside the "No Hands Zone". The "No Hands zone" is
defined as the area between marked lines on the left and
right side of the Base, including the entire Table and
portion of the Fence within these marked lines. This zone
is labeled by "No Hands" symbols placed just inside the
marked lines on the Base. Always use clamp to hold
workpiece against the table and fence when making
compound miter cuts. Do not support by hand.
• Hold workpiece firmly to the fence to prevent movement.
• Keep hands in position until trigger has been released
and blade has stopped completely.
• Keep feet firmly on the floor and maintain proper balance.
• Follow the miter arm when mitering left or right. Stand
slightly to the side of the saw blade.
• Sight through the lower guard if following a pencil line.
• Before making any cut, with the power off, lower the blade
to preview the blade path.
W RNING
this occurs:
• Typically this may occur when trying to cut workpieces
that are near the maximum cutting height capacity. Under
these conditions, the workpiece can stop the lower guard
movement before the downward motion of the arm could
preopen the lower guard. If this occurs:
• Workpiece must be securely clamped. This frees your left
hand to raise the guard 1 by the lip 2 just enough to clear
the workpiece (Figure 21).
• Start the saw and begin your cut.
• Once you have cleared the position where the lower
guard may bind, release the guard and it will continue to
raise automatically as you cut.
Be aware of the path of the saw blade. Make a dry run with
the saw OFF by conducting a simulated cutting cycle, and
observe the projected path of the saw blade. Keep hands
out of the path of saw blade.
DRY RUN—It is important to know where the blade will
intersect with the workpiece during cutting operations. Always
perform the simulated cutting sequence with the power tool
switched OFF to gain an understanding of the projected
path of the saw blade. Mentally note where the path of saw
blade will fall and set up your work to keep your hands and
arms out of the path of the spinning blade. Adjust your
clamps and fences so that the smooth lower guard and
cutting action is not interfered with during cutting operation.
Position your body and hands properly to
make cutting easier and safer. Observe
The lower guard may not automatically
open under certain cutting conditions. If
Correct Use
Correct Use
38
FIG. 19
Incorrect Use
Incorrect Use
FIG. 21
2
1