Operating Instructions; General Glass Information; Louvre Removal; Glass Cleaning - Vermont Castings LHERDV20 Owners Installation And Operating Manual

LHEDV Series Direct Vent Insert

General Glass Information

Only ceramic glass approved by Vermont
Castings Group may be used for replacement
on this unit.
1. ��he use of substitute glass will void all product
warranties.
. Care must be taken to avoid breakage of the glass.
3. �nder no circumstances should this appliance be
operated without glass properly installed, or with any
cracked or broken glass. Replacement of any glass
assembly as supplied by the manufacturer should be
done by a licensed qualified service person.

Louvre Removal

��o remove louvre,
lift louvre up and
then pull out.
(Fig. 0)
FP444
Fig. 20 Louvre removal.

Glass Cleaning

It will be necessary to clean the glass periodically. During
start-up condensation, which is normal, forms on the inside
of the glass and causes lint, dust and other airborne particles
cling to the glass surface. Also initial paint curing may deposit
a slight film on the glass. It is therefore recommended that
the glass be cleaned two or three times with a non-ammonia
household cleaner and warm water (we recommend gas
fireplace glass cleaner). After that the glass should be
cleaned two or three times during each heating season
depending on the circumstances present.
Clean glass after first two weeks of opera-
tion.
14

Operating Instructions

2.
Louvre
1.
Glass Panel

Glass Frame Removal

LHECDV20 and LHERDV20
1. Remove two () screws at the bottom of the frame.
(Fig. 17)
. Lift up and unhook glass frame at the top.
LHECDV30 and LHERDV30
1. �nhook the frame window by pulling the handle of the
two () latches at the bottom part of the window frame;
pull the left side latch counterclockwise and the right
side latch, clockwise. (Fig. 1)
. Lift and unhook the glass frame at the top.
Machine �crew
Latch
Fig. 21 Remove glass frame.
Log Installation and Burner Lava Rock
FP1327
1 . Remove glass frame. (�ee "Glass Removal" section)
window frame removal
4/3/03 djt
. Remove logs from packaging.
3. Place logs according to the model instructions below:
LHECDV20, LHERDV20 (Fig. )
a. Place rear left log (JR7). �se the log's bottom holes
to locate it onto one pin stud of the rear log bracket
on the left and the other end of the log will sit on top
of the lid of the left log support.
b. Place rear right log (JR8). �se the log's bottom holes
to locate it onto the two () pin studs of the rear log
bracket on the right.
c. Place the front left log (JR9). Position the log notch
against the second grate from the left, and the other
edge of the log on top of the rear left log notch. ��nsure
the log is secure in place.
FP138
10004894