technical speciFication
The I22 uses proprietary UFPD power technology to provide high power output
with very low distortion, with an ecologically-friendly low standby power.
F e a t u r e s
Ultra Fast Power Device (UFPD) Class-D
Amplifier
26dB constant loop gain in the entire audio range
Power Factor Control (PFC) power supply
s p e a k e r o u t p u t s
Power
2 x 80W into 8Ω, 2 x 160W into 4Ω
a n a l o g u e o u t p u t s
Preamplifier output
RCA, 94Ω impedance.
Record output
RCA, 94Ω impedance.
i n p u t s
4 x RCA, 15kΩ impedance.
o p t i o n a l d a c b o a r d
1x Digital Optical input (TOSlink)
1x Digital Coaxial input (RCA)
1x USB-B input
p e r F o r m a n c e
Frequency response
10Hz – 20kHz, -0.5dB
THD
<0.05%, 20Hz – 20kHz, 10W into 8Ω
Signal to noise ratio
-95 dBv
g e n e r a l
Control
1 x 12V trigger output
1 x RS232
Power supply
90V -5% to 240V +5%
Power consumption
Standby: 0.3W
Operating: 19W
Size
430 x 420 x 106mm (WxDxH)
Weight
10kg
Colour
Black or titanium
additional inFormation
These instructions help you get the best possible sound from your I22, and give
information about using it with a CD22.
p h a s e
The phase of the AC supply can make a significant
difference to the sound.
Ensure that the live pin of the AC power cable
is connected to the left-hand pin of the power
connector, viewed from the back panel:
Live
b u r n - i n
Your Primare will start to sound best after an
initial burn-in of approximately 24 hours.
You will notice a further smaller improvement in
sound quality for at least another 3 days' playing.
r s 2 2 a n d t r i g g e r
The RS232 input allows you to connect the I22 to
a controller system. For more information please
contact Primare or visit www.primare.net.
The Trigger output allows the I22 to switch on
other devices, such as a CD22.
i 2 2 u s e r g u i d e
u s i n g t h e i 2 2 W i t h a
c d 2 2
Your I22 is an ideal companion to the Primare
CD22 CD Player. For best results link the two
products together as follows using the two cables
supplied with the I22:
To connect the trigger cable
The Trigger cable ensures that the CD22 switches
on, or to standby, when you operate the
O
button on the front panel of the
I22.
•
Connect the Trigger cable from the I22 TRIG
OUT to the CD22 TRIG IN.
•
Configure the CD22 to TRIG ON.
To connect the IR cable
The IR cable ensures that the remote control
O
DIM and
buttons operate both units in
synchrony.
•
Set the I22 and CD22 to the same display
brightness setting.
•
Connect the IR cable from the I22 IR OUT to
the CD22 IR IN.
•
Configure the CD22 to IR BACK.
Refer to the CD22 User Guide for details of
how to configure the TRIG ON and IR BACK
settings.