Connecting The Cables; Serial Cable (Rs-232C) - BIXOLON SRP-330 User Manual

1-2 Connecting the Cables

Connect the cable that is suitable for the specifications of the printer and the host computer
(POS/ECR) to the printer and the host computer. The specification of the drawer should
match the printer specifications.
※ NOTE
Before connecting any of the cables, make sure that both the printer and the host are turned
off.

1-2-1 Serial Cable (RS-232C)

PRINTER
SIDE
(Male 25P)
Pin No. Signal Name
BODY Frame GND
2 TXD
3 RXD
6 DSR
7 Signal GND
20 DTR
Shield Frame GND
Rev. 1.01
HOST PRINTER
SIDE SIDE
(Female 25P) (Male 25P)
Signal Direction
- Frame Ground
Output Transmit Data
Input Receive Data
This signal indicates whether the host computer can receive
data. (H/W flow control)
1) MARK(Logic1) : The host can receive a data.
2) SPACE(Logic0) : The host can not receive a data.
Input
3) The printer transmits a data to the host, after confirming
4) When XON/XOFF flow control is selected, the printer
- Signal Ground
This signal indicates whether the printer is busy. (H/W flow
control)
1) MARK(Logic1) : The printer is busy.
2) SPACE(Logic0) : The printer is not busy.
Output
3) The host transmits a data to the printer, after confirming
4) When XON/XOFF flow control is selected, the host does
- Frame Ground
Drawer kick-out
connector
HOST
SIDE
(Female 9P)
Function
this signal.
does not check this signal.
this signal.
not check this signal.
- 8 -
SRP-330
PRINTER
SIDE
(Male 9P) (Female 9P)
HOST
SIDE