Auxiliary Harness (H2) - Viper 5601 Installation Manual

Security and remote start

Hide thumbs Also See for 5601:

Table of Contents

(+) Positive Light Flash Output

WHITE H1/11

(+) LIGHT FLASH OUTPUT

(-) Negative Light Flash Output

WHITE H1/11

(-) LIGHT FLASH OUTPUT

Note: For parking light circuits that draw 10-amps or more, the internal jumper

must be switched to a (-) light flash output. (See Setting the light flash polarity

section of this guide.) P/N 8617 or a standard automotive SPDT relay must be

used on the H1/11 light flash output harness wire.

H1/12

ORANGE

(-) 500mA GROUND WHEN ARMED OUTPUT

This wire supplies a (-)500 mA ground as long as the system is armed. This

output ceases as soon as the system is disarmed. The GWA can be hooked up

to a window module, a voice module or any accessory that requires a ground

when armed.

➤ Auxiliary harness (H2)

H2/1

LIGHT GREEN/BLACK

(-) 200mA FACTORY ALARM DISARM OUTPUT

This wire sends a negative pulse every time the remote start is activated , chan-

nel 2 is activated (programmable on/off) or when the doors are unlocked with

the remote. This can be used to pulse the disarm wire of the vehicle's factory anti-

theft device. Use a relay to send a (-) or (+) pulse to the disarm wire as shown

in the following diagrams.

Table of Contents

Show Quick Links

Table of Contents