Limited Warranty; Specifications - Audio Research Reference 5 SE Owner's Manual

Limited Warranty

Audio Research Corporation products are covered
by a 3-Year Limited Warranty, or a 90-Day Limited
Warranty (vacuum tubes).
initiates from the date of purchase, and is limited to
the original purchaser,
demonstration equipment, limited to the balance
of warranty remaining after original shipment to the
retailer or importer.
In the United States, the specific terms, conditions
and remedies for fulfillment of this Limited Warranty
are listed on the warranty card accompanying the
product in its shipping carton, or may be obtained
from the authorized retailer or from the Audio
Research Customer Service Department. Outside
the United States, the authorized importing retailer
or distributor has accepted the responsibility for
warranty of Audio Research products sold by them.
The specific terms and remedies for fulfillment of the
Limited Warranty may vary from country to country.
Warranty service should normally be obtained from
the importing retailer or distributor from whom the
product was purchased.
In the unlikely event that technical service beyond
the ability of the importer is required, Audio
Research will fulfill the terms and conditions of the
Limited Warranty. Such product must be returned
at the purchaser's expense to the Audio Research
factory, along with a photocopy of the dated
purchase receipt for the
description of the problem(s) encountered, and
any information necessary for return shipment. The
cost of return shipment is the responsibility of the
purchaser.
This Limited Warranty
or in the case of
product, a written

Specifications

FREQUENCY RESPONSE: +0-3dB, 0.5Hz to 200kHz at
rated output (Balanced, 200k ohms load).
DISTORTION: Less than .01% at 2V RMS BAL output.
GAIN: Main output: 12dB Balanced output, 6dB SE
output. Tape output: 0dB (Processor input: 0dB SE
output).
INPUT IMPEDANCE: 120K ohms Balanced, 60K ohms
SE. Inputs (7): CD, TUNER, VIDEO, PHONO, AUX 1,
AUX 2, PROCESSOR. (XLR and RCA connectors)
OUTPUT IMPEDANCE: 600 ohms Balanced, 300 ohms
SE Main (2). 20K ohms minimum load and 2000pF
maximum capacitance. Outputs (3): 2 main, 1
tape (XLR and RCA connectors).
OUTPUT POLARITY: Non-inverting.
MAXIMUM INPUT: 20V RMS BAL, 10V RMS SE.
RATED OUTPUTS: 2V RMS (1V RMS SE) into 200K ohm
balanced load (maximum balanced output
capability is 30V RMS at less than 0.5% THD at
1kHz).
CROSSTALK: -80dB or better at 1kHz and 10 kHz.
CONTROLS: Volume (104 steps), Select Input. Push
Buttons: Power, Proc, BAL/SE, Mono, Invert, Mute.
POWER SUPPLIES: Electronically regulated low and
high voltage supplies. Automatic 40 sec. warm-
up/brown-out mute. Line regulation better than
.01%.
NOISE: 1.7uV RMS residual IHF weighted balanced
equivalent input noise with volume at 1 (109dB
below 2V RMS output.)
TUBE COMPLEMENT: (4)-6H30P dual triodes, plus (1
each) 6550C and 6H30P in power supply.
POWER REQUIREMENTS:
270VAC 50/60Hz) 130 watts. Standby: 2 watts.
DIMENSIONS: 19" (48 cm) W x 7" (17.8 cm) H
(standard panel) x 15.5" (39.4 cm) D.
extend 1.5" (3.8 cm) forward of the front panel.
WEIGHT: 30.4 lbs. (13.9 kg) Net; 41.6 lbs. (19 kg)
Shipping.
Specifications subject to change without notice.
©2011 Audio Research Corporation.
100-135VAC 60Hz (200-
Handles
9