Specifications; Disposal And Recycling Guidelines; Limited Warranty - Audio Research Reference 610T Owner's Manual

Model Reference 610T

Disposal and Recycling Guidelines

To dispose of this electronic product, do not place in land-
fill. In accordance with the European Union Waste Electri-
cal and Electronic Equipment (WEEE) directive effective
August 2005, this product may contain regulated materials
which upon disposal require special reuse and recycling
processing.
Please contact your dealer or importing distributor for
instructions on proper disposal of this product in your
country. Or, contact Audio Research Corporation (763-577-
9700) for the name of your importing distributor and how
to contact them.
Packing and shipping materials may be disposed of in a
normal manner.

Limited Warranty

Audio Research Corporation products are covered by a
3-Year Limited Warranty or a 90-Day Limited Warranty
(vacuum tubes). This Limited Warranty initiates from the
date of purchase, and is limited to the original purchaser, or
in the case of demonstration equipment, limited to the
balance of warranty remaining after original shipment to
the retailer or importer.
In the United States, the specific terms, conditions and
remedies for fulfillment of this Limited Warranty are listed
on the warranty card accompanying the product in its ship-
ping carton, or may be obtained from the authorized retail-
er or from the Audio Research Customer Service Depart-
ment. Outside the United States, the authorized importing
retailer or distributor has accepted the responsibility for
warranty of Audio Research products sold by them. The
specific terms and remedies for fulfillment of the Limited
Warranty may vary from country to country. Warranty ser-
vice should normally be obtained from the importing retail-
er or distributor from whom the product was purchased.
In the unlikely event that technical service beyond the abil-
ity of the importer is required, Audio Research will fulfill
the terms and conditions of the Limited Warranty. Such
product must be returned at the purchaser's expense to the
Audio Research factory, along with a photocopy of the
dated purchase receipt for the product, a written descrip-
tion of the problem(s) encountered, and any information
necessary for return shipment. The cost of return shipment
is the responsibility of the purchaser.

Specifications

POWER OUTPUT: 600 watts continuous at 16 ohms
from 20Hz to 20kHz. 1kHz total harmonic distortion typically
0.5% at 600 watts, below .05% at 1 watt.
Approximate actual power available at "clipping" 630 watts
(1kHz). (Note that actual power output is dependent upon
both line voltage and "condition" i.e.: if power line has high
distortion, maximum power will be affected adversely.
POWER BANDWIDTH: (-3dB points) 15Hz to 150kHz.
FREQUENCY RESPONSE: (-3dB points at 1 watt)
1Hz to 200 kHz.
INPUT SENSITIVITY: 4.2V RMS balanced for rated output.
(24dB Gain into 8 ohms)
INPUT IMPEDANCE: 200K ohms balanced.
OUTPUT: 4, 8, 16 ohms.
OUTPUT REGULATION: Approximately 0.8dB 16 ohm load
to open circuit (Damping factor approximately 16).
OVERALL NEGATIVE FEEDBACK: 13dB.
POWER SUPPLY ENERGY STORAGE: Approximately
1000 joules.
POWER REQUIREMENTS: 105–125VAC 60Hz
(210 –250VAC 50Hz) 1700 watts at rated output, 2300 watts
maximum, 800 watts at idle, 370 watts standby.
TUBES REQUIRED: 8 Matched pair 6550C Power Output;
1–6550C Regulator; 1–6H30.Regulator Amplifier; 2–6L6GC
Driver; 2– 6NIP input, 1–6H30 Follower.
DIMENSIONS: 13.5" (34.3 cm) W x 23" (58.4 cm) H x (20.8"
(52.8 cm) D. Handles extend 1.5" (3.8 cm) forward and
rearward..
WEIGHT: 170 lbs. (77.2 kg) Net; Shipped in pairs, 395 lbs.
(180 kg) per pair.
Specifications subject to change without notice.
©2005 Audio Research Corporation
5