Download Print this page

Limited Warranty; Specifications - Audio Research DS450 Owner's Manual

Definition series

Advertisement

Model DS450

Limited Warranty

Audio Research Corporation products are covered by a 3-
Year Limited Warranty, or a 90-Day Limited Warranty
(vacuum tubes). This Limited Warranty initiates from the
date of purchase, and is limited to the original purchaser, or
in the case of demonstration equipment, limited to the
balance of warranty remaining after original shipment
to the retailer or importer.
In the United States, the specific terms, conditions and
remedies for fulfillment of this Limited Warranty are
listed on the warranty card accompanying the product in
its shipping carton, or may be obtained from the authorized
retailer or from the Audio Research Customer Service
Department. Outside the United States, the authorized
importing retailer or distributor has accepted the responsi-
bility for warranty of Audio Research products sold by
them. The specific terms and remedies for fulfillment of
the Limited Warranty may vary from country to country.
Warranty service should normally be obtained from the
importing retailer or distributor from whom the product
was purchased.
In the unlikely event that technical service beyond the
ability of the importer is required, Audio Research will
fulfill the terms and conditions of the Limited Warranty.
Such product must be returned at the purchaser's expense
to the Audio Research factory, along with a photocopy of
the dated purchase receipt for the product, a written
description of the problem(s) encountered, and any infor-
mation necessary for return shipment. The cost of return
shipment is the responsibility of the purchaser.
4

Specifications

POWER OUTPUT: 450 watts into 8 ohms (550 watts
per channel into 4 ohms), both channels driven, 1% THD.
(700 watts into 4 ohms, one channel driven)
POWER BANDWIDTH: (-3dB Points) 5Hz to 45 kHz into
8 ohms.
FREQUENCY RESPONSE: (-3dB points at 1W) 5Hz to
45 kHz
INPUT SENSITIVITY: 2.9V RMS for rated output (26dB Gain)
single-ended or balanced.
INPUT IMPEDANCE: 150K ohms single-ended, 300K ohms
balanced differential.
OUPUT POLARITY: Non-inverting from single-ended inputs.
Balanced pin 2+ (IEC-268).
OUTPUT REGULATION: 0.02dB 8 ohm load to open circuit
(Damping factor 440).
OUTPUT CURRENT: 35 amps peak at protective shutdown.
SLEW RATE: 5 volts/microsecond. (20% maximum duty
cycle).
RISE TIME: 8.0 microseconds.
HUM & NOISE: 300 microvolts RMS (105dB below rated
output IHF A-weighted).
POWER SUPPLY CAPACITANCE: 217,000 uF total.
POWER REQUIREMENTS: 100-125VAC 60Hz
(200-250VAC 50Hz) 950 watts at rated output (400WPC
8 ohms), 1300 watts at 550WPC 4 ohms, 1300 watts
maximum, 55 watts idle.
DIMENSIONS: 19" (48 cm) W (standard rack panel) x 7"
(17.8 cm) H x 18.4" (46.7 cm) D (front panel back). Handles
extend 1.5" (3.8 cm) forward of the
Output connectors extend 1.5" (3.8 cm) behind rear panel.
WEIGHT: 55.8 lbs. (25.4 kg) Net; 71 lbs. (32.3 kg) Shipping.
Specifications subject to change without notice.
©2009 Audio Research Corporation.
3
/
" thick front panel.
8

Advertisement

loading