Room Air Fan; Re-Starting A Warm Stove; If Stove Runs Out Of Pellets; Refueling - Breckwell The Big E Owner's Manual

ROOM AIR FAN

When starting your stove, the Room Air Fan will not come on until the stove's heat exchanger warms up. This usually takes about 10
minutes from start-up.

RE-STARTING A WARM STOVE

If the stove has been shut off, and you want to re-start it while it is still warm, the "On/Off" button must be held down for 2 seconds.

IF STOVE RUNS OUT OF PELLETS

The fi re goes out and the auger motor and blowers will run until the stove cools. This will take 30 to 45 minutes. After the stove compo-
nents stop running, the "On/Off" and the Bar Graph lights stay on for 10 minutes. After the 10 minutes, the "3" light on the bar graph will
fl ash and the "On/Off" light will go off. To re-start, refi ll hopper and press "Fuel Feed" button until pellets begin to fall into burnpot. Press
"On/Off" button.

REFUELING

We recommend that you not let the hopper drop below 1/4" full.
KEEP HOPPER LID CLOSED AT ALL TIMES EXCEPT WHEN REFILLING. DO NOT OVERFILL HOPPER.

BRECKWELL MAINTENANCE TOOL

A tool has been provided to help with the following functions:
FIGURE 13
a. Stirring pellets in hopper - unlike liquids in a tank, pellets do not drain evenly into the auger. Bridging across the opening can occur
Pellets can hang up on the sides of the hopper. Occasionally "stirring" the hopper can help.
NOTE: To help prevent bridging of pellets, common wax paper can be rubbed on the sidewalls and bottom of the hopper.
b. Scrape ashes from burnpot.

SHUTDOWN PROCEDURE

Turning your Breckwell stove off us a matter of pressing the "On/Off" control panel switch. The red light will go out. The blowers will con-
tinue to operate until internal fi rebox temperatures have fallen to a preset level.

SAFETY FEATURES

a. Your stove is equipped with a high temperature thermosdisc. This safety switch has two functions.
1. To recognize an overheat situation in the stove and shut down the fuel feed or auger system.
2. In case of a malfunctioning convection blower, the high-temperature thermodisc will automatically shut down the auger,
preventing the stove from overheating.
NOTE: On some units, once tripped, like a circuit breaker, the reset button will have to be pushed before restarting your stove. On other
units, the thermodisc has no reset button and will reset itself once the stove has cooled. The manufacturer recommends that you call your
dealer if this occurs, as this may indicate a more serious problem. A service call may be required.
b. If the combustion blower fails, an air pressure switch will automatically shut down the auger.
NOTE: Opening the stove door for more than 30 seconds during operation will cause enough pressure change to activate the air switch,
shutting the fuel feed off. Close the door and press "On/Off" button to continue operation of your stove.
OPERATION OPERATION
13 13