Table of Contents
Advertisement
Quick Links
Owner's Operation and Instruction Manual
Window Pellet Unit
CAUTION!
Read All Instructions Carefully
Before Starting The Installation or
Operating This Heater.
Improper Installation Could Void
Your Warranty!
THIS MANUAL WILL HELP YOU TO OBTAIN EFFICIENT, DEPENDABLE SERVICE FROM THE HEATER, AND ENABLE YOU TO ORDER
BRECKWELL
Exceptional Heat, Outstanding Value
227 Industrial Park Road
P.O. Box 151
South Pittsburg, TN 37380
Ussc
WINDOW PELLET HEATER
SP8000
SAFETY TESTED TO ASTM 1509-04 & ULC S-627-00
SAVE THIS MANUAL FOR FUTURE REFERENCE
REPAIR PARTS CORRECTLY. KEEP IN A SAFE PLACE FOR FUTURE REFERENCE.
®
®
-
MODEL
PATENT NO.: 7,686,011
SAFETY NOTICE:
If this heater is not properly installed, a house fire
may result. For your safety, follow the installation in-
structions. Contact your local building or fire officials
about obtaining a permit, restrictions and installation
requirements in your area.
C
US
CM
1
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Breckwell ECO-AIRE SP8000
Summary of Contents for Breckwell ECO-AIRE SP8000
- Page 1 Owner’s Operation and Instruction Manual Window Pellet Unit WINDOW PELLET HEATER MODEL SP8000 PATENT NO.: 7,686,011 SAFETY TESTED TO ASTM 1509-04 & ULC S-627-00 SAFETY NOTICE: CAUTION! If this heater is not properly installed, a house fire Read All Instructions Carefully may result.
-
Page 2: Safety Precautions
Safety Precautions IMPORTANT: Read this entire manual before Disconnect the power cord before performing any installing and operating this product. Failure to do maintenance! NOTE: Turning the ON/OFF Switch so may result in property damage, bodily injury, to ”OFF” does not disconnect all power to the or even death. - Page 3 WARRANTY INFORMATION CARD Name__________________________________________ Telephone #: (_____)_____________ City____________________________________________ State_______ Zip_________________ Email Address __________________________________________________________________ Model # of Unit________________________________ Serial #___________________________ Fuel Type: qWood qOther _________________________ qCoal qPellet qGas Place of Purchase (Retailer)______________________________________________________ City____________________________________________ State_______ Zip_________________ If internet purchase, please list website address___________________________________ Date of Purchase _______________________________________________________________ Reason for Purchase: qAlternative Heat...
- Page 4 Ê É Fold Here Fold Here Fold Here PLACE STAMP HERE United States Stove Company P.O. Box 151 South Pittsburg, TN 37380 Ussc...
-
Page 5: Fuel Considerations
Specifications Heating Specifications BTU output will vary depending on the quality of fuel. Use Heat Output 16,400 BTU/hr. PFI listed fuels for the best results. Heating Capacity 500 - 1,000 sq. ft. Heating capacity will vary depending on floor plan layout of your home, degree of insulation, and the outside Fuel Burn Rate ¾... -
Page 6: Installation
Assembly Your Eco-Aire heater comes pre-assembled with the exception of the Spark Suppressor that needs to be attached to the rear of the unit on the ex- haust outlet. DO NOT OPERATE THIS HEATER WITH THE SPARK SUP- PRESSOR REMOVED! Using the hardware and gasket supplied, attach the suppressor to the rear of the unit as shown in the illustration. -
Page 7: Floor Protection
Installation FLOOR PROTECTION This heater must have a non-combustible floor protector (ember protection) installed beneath it if the floor is of combustible material. If a floor pad is used, it should be UL listed or equal. The floor pad or non-combustible surface should be large enough to extend a minimum of 6-inches [152mm] in front and 2-inches [51mm] on each side of the heater. -
Page 8: Window Installation
Window Installation When Installing your heater in a window • Select a window of adequate size and with the ap- propriate clearances needed for a safe installation. The mounting hardware supplied is designed for the appliance to be installed in the approximate center of the window. - Page 9 Window Installation TWO-SIDED TAPE WINDOW Sill MOUNT- ING BRACKETS SCREW Installing the filler panels • Begin by assembling the left and right side filler panels together. Slide part A into part B; Notice the range of adjustment. If the openings on each side of the heater exceeds this range, you will have to fill the gap by other means necessary to keep the window/ opening weather tight.
-
Page 10: Wall Installation
Wall Installation When Installing your heater in an exterior wall [648mm] • Select a wall to the exterior of the building. This wall should have the required clearance to combustibles inside and out mentioned earlier in this manual. Make certain that electrical wires, conduit, water or gas pipes do not pass through the area you have selected •... -
Page 11: Understanding Your Heater
Understanding your heater How your heater works Your Eco-Aire pellet heater operates on a timer based auger fuel feed system, that is controlled by a digital circuit board. The fuel is delivered from the auger into a burn pot, which is the vessel where the combustion process takes place. -
Page 12: Operation
Operation UNIT PREPARATION After properly installing your heater, you will need to perform the following steps before operation: • Attach the electrical cord to the left side blower housing first; then plug it into a 110-volt outlet (an outlet surge protector is highly recommended). PERFORMING AN INITIAL BURN You must perform an initial burn in this appliance before installing it in your home or garage. -
Page 13: Daily Operation
Operation DAILY OPERATION Never place your hand near the auger while the heater is in operation. This unit should be filled when the hopper level drops below 3-inches. In the event of a power outage, the heater WILL NOT function. If the unit was “ON” when the power outage occurred, one of the following will take place: 1.) If the heater is still warm, it will resume feeding fuel and continue to operate normally. -
Page 14: Yearly Servicing
Maintenance ASH DISPOSAL Ashes should be placed in a metal container with a tight fitting lid. The closed container of ashes should be placed on a noncombustible floor or on the ground, well away from all combustible materials, pending final disposal. -
Page 15: Trouble Shooting Errors
Trouble Shooting Errors Disconnect the power cord before performing any maintenance! NOTE: Switching the appliance to ”OFF” does not disconnect all power to the electrical components of the heater. Never try to repair or replace any part of the heater unless instructions for doing so are given in this manual or supplied from the factory. -
Page 16: Parts Diagram
Parts Diagram LEFT SIDE RIGHT SIDE FOAM INSULATOR PANEL FILLER PANELS CUT-TO-SIZE Ussc... - Page 17 Parts List 2400 Item Part No. Title Qty. 88033 3/8” Rope Gasket 3 FT 891544 Glass, Combustion Chamber 891951 Latch, Door 83339 1/4-20 Bolt 83261 1/4-20 Lock Nut 88144 Gasket, Cleanout 891952 Draw Latch 891542 Latch, Push-to-Close/Microswicth 80573 Blower, Exhaust - 70CFM 88129 Gasket, Exhaust Blower 891702...
-
Page 18: Wiring Diagram
Wiring Diagram Ussc... - Page 19 Notes Ussc...
-
Page 20: How To Order Repair Parts
How to order repair parts This manUal will help yoU obTain efficienT, dependable service from yoUr eco-aire, and enable yoU To order repair parTs correcTly. Keep This manUal in a safe place for fUTUre reference. when wriTing, always give The fUll model nUmber which is on The nameplaTe aTTached To The heaTer. when ordering repair parTs, always give The following informaTion as shown in This lisT: 1. The parT nUmber 2. The parT descripTion 3. The model nUmber: 2400 4. The serial nUmber:____________________ United states stove company 227 industrial park road p.o. box 151 south pittsburg, Tn 37380 (800) 750-2723 www.UssTove.com Ussc...
Need help?
Do you have a question about the ECO-AIRE SP8000 and is the answer not in the manual?
Questions and answers