Mitsubishi Electric MCF-13NV-E3 Service Manual page 31

OPERATING PROCEDURE
3. Removing the propeller fan and the outdoor fan
motor
(1) Remove the cabinet. (Refer to 1.)
(2) Remove the propeller fan nut.
(3) Remove the propeller fan.
NOTE : Loose the propeller fan in the rotating direction for
removal.
When attaching the propeller fan, align the mark on the
propeller fan and the motor shaft cut section.
Set the propeller fan in position by using the cut on the
shaft and the mark on the propeller fan.
(4) Remove lead clamps and fan motor lead wires.
(5) Remove screws fixing the fan motor.
(6) Remove the outdoor fan motor.
4. Removing the compressor
(1) Remove the cabinet. (Refer to 1)
(2) Remove the relay panel.
(3) Remove the soundproof felt.
(4) Remove the terminal cover on the compressor.
(5) Disconnect lead wires from the glass terminal of the
compressor.
(6) Release gas from the refrigerant circuit.
(7) Disconnect the welded part of the discharge pipe.
(8) Disconnect the welded part of the suction pipe.
(9) Remove nuts fixing the compressor.
( 10 ) Remove the compressor.
NOTE
Before using a burner, purge gas from the pipes until the
pressure gauge shows 0 kg/cm
Use the burner under the condition that gas can be released
even when the inner pressure rises by heat.
2 .
Photo 5
Set screws of
outdoor fan motor
Propeller fan
Propeller fan nut
Photo 6
Discharge pipe
Glass
terminal
Compressor
Compressor
set nuts
31
PHOTOS
Hook
Lead clamps
Outdoor
fan motor
Suction pipe
Terminal cover