Sharp MX-5500N Manual page 18

3
• Up to 999 copies (sets) can be set.
• A single copy can be made even if "0" appears for the number of copies.
If an incorrect number of copies is set...
Press the [CLEAR] key (
4
Even if a colour mode is selected, copying will take place in black and white if the [BLACK & WHITE START] key
( ) is pressed.
5
Place next original. Press [Start].
When finished, press [Read-End].
6
To cancel scanning of the original and copying...
Press the [STOP] key (
7
Special Modes
2-Sided Copy
Plain
A4
) and then enter the correct number.
or
or
Read-End
).
Set the number of copies (number of
sets) with the numeric keys.
Press the [COLOUR START] key
( ) or the [BLACK & WHITE
START] key (
Normally copying will start.
Depending on the copy settings (2-sided copying, etc.), copying
may not begin until all originals have been scanned. In this
case, go to the next step.
Remove the original and place the next
original, and then press the [COLOUR
START] key (
WHITE START] key (
Repeat this step until all originals have been scanned.
For the second original and following originals, use the same
[START] key as you did for the first original.
Touch the [Read-End] key.
18
).
) or the [BLACK &
).