Connecting A Video Component With Dv Connector - JVC GY-DV300 Instruction Manual

EXTERNAL COMPONENTS
Connecting the GY-DV300 to another video component equipped with DV I/O connector (IEEE1394
standard) using a DV cable (optional) enables dubbing of digital signals with high picture quality and
high-quality sound.
MODE
switch
MODE
BAR
CAM-B
CAM-A
button
BAR
AW
AW button
When using the GY-DV300 as playback unit (dubbing to another videocassette)
● Pressing the BAR button during
playback engages the still
mode.
● When a still picture is dubbed,
the dubbed picture will be
coarse. Noise may also appear
in the sound.
● When the BR-DV600UA's TC
DUPLICATE mode is used, the
time code data played back on
the GY-DV300 can also be
dubbed.
Memo:
● The operation methods differ with the characteristics and specifications of the connected equipment.
Even if connection is possible, operation or data communication may sometimes be impossible to
perform.
● When a D-9 (digital S) component is connected by means of IEEE1394, data and time data is not
output from the D-9 component. Also, data and time data is not recorded on the D-9 component.
● If noise appears on the screen or the sound drops out, disconnect the DV cable and then connect it
again or turn off the GY-DV300 before turning it on again.
● Audio noise may be heard when turning on/of f the device connected to the DV connector or when
switching video input. When performing these types of operations, turn the volume of the audio
device, speakers, etc., connected to GY-DV300U to minimum.
84
VTR
1.
Connect the units with the DV cable.
2.
Turn ON both units.
3.
Set the MODE switch on the GY-DV300 to "VTR".
4.
Insert the videocassettes.
GY-DV300: Insert the recorded videocassette.
Recording unit: Insert the videocassette to be dubbed to.
5.
Press the BAR button on the GY-DV300 to start playback.
6.
Start recording on the recording unit.
For details, see the instructions to the unit used for recording.
7.
When dubbing is completed.
Stop recording on the recording unit, and then press the AW
button on the GY-DV300 to stop playback.
Connecting a Video Component
with DV Connector
REC START/STOP button
DV connector
DV cable: VC-VDV204 (4P-4P)
VC-VDV206 (4P-6P)
DV connector