Table of Contents
Advertisement
Appendix
Safety instructions
–
Only a protective case may be used which is authorised for use with
this unit in hazardous areas.
–
Before a unit which has been opened or repaired is switched on again,
it must be tested in compliance with ElexV §9 by a technician in
compliance with ElexV §15 or must be subject to a routine test by the
manufacturer.
–
Units which are clearly damaged or even only suspected of being
damaged must not be brought into the hazardous area, or they must be
switched off immediately and taken out of the hazardous area. Prevent
switching on the unit unintentionally.
–
Any change to the unit or its components not authorised by the
manufacturer will invalidate the operating licence of the unit.
–
Observe all safety regulations. They protect not only your life!
Repair procedure for explosion-proof unit models
Defective units must not be replaced with new units via a unit exchange
pool (ready ware) but must be sent for repair to our repair centre for
explosion-proof units. The stipulated routine test by the manufacturer
is then guaranteed.
–
Units which are to be repaired must always be sent in with the
explosion-proof battery pack.
–
To prevent the explosion-proof battery pack from becoming exhausted,
disconnect the battery pack from the unit prior to dispatch!
–
The individually repaired and tested unit is then returned to the
customer.
The address of our repair centre is:
Tenovis GmbH & Co. KG
Zentralreparatur Funkruf / Mobility
John-F.-Kennedy-Straße 43-53
38228 Salzgitter
92
Integral 33/55
Advertisement
Table of Contents
