Model No MX0402-321 Operating Instructions Thanks for purchasing our product. Please be sure to read this instruction manual Carefully before using our product.
Page 2
Introduction The Sewell Spider is a 4-by-2 HDMI true matrix. It allows any source (Blue-Ray player, HD DVD player, satellite receiver, game system, etc.) to be shown on the any of the two displays simultaneously, no matter the source is HDCP or not.
HDMI Matrix Product Overview ■ Features ■ Easy to use: install in seconds, no need for setting. Allows up to four HDMI source devices to be independently switched to two HDMI monitors, HDTVs, or projectors. The two outputs could show the same or different source at the same time ...
Page 6
Warning To reduce the risk of fire, electric shock or product damage: 1. Do not expose this apparatus 6. Clean this apparatus to rain, moisture, dripping or only with dry cloth. splashing and that no objects filled with liquids, such as vases, shall be placed on the apparatus.
Package Contents ■ ① Main unit. ② 5VDC Power Supply. ③ 1x Remote. ④ 2x IR_RX (IR receiver) extension cable. ⑤ 4x IR_TX (IR emitter) extension cable. ⑥ 2x IR_RX cable extender jack pair. ⑦ Operating Instructions ⑧ 2x Mounting Ear. Specifications ■...
Panel Descriptions ■ Front Panel ① IR receiver. ② Indicator of inputs (2 color LED, RED for Output1, BLUE for Output 2). ③ Input select button for Output 1. ④ Input select button for Output 2. ⑤ IR extension transmitter sockets. ⑥...
Side Panel DIP switch for EDID setting. Installation ■ Connect the HDMI input sources ( such as HD-DVD, PS3, STB etc) into the matrix. Connect the HDMI outputs ( such as HD-LCD, HD-DLP) into the matrix. Power on the input source you want to show. ( Keep the unused input power off, otherwise it may interfere the normal display.) Connect the power supply into matrix and turn on the display you want to...
Operation ■ 1. Front panel control. The MX0402-321 front panel to select inputs to the various outputs. 2. Local IR remote control. User can control the HDMI route of the matrix by using the IR remote. There are two group key pads for two output ports.
Page 11
3. IR extender control. User can use the IR receiver cable to change the IR receiver position. If controlling the matrix through the 1/8” (3.5 mm) input jack on the rear panel, connect the IR cable directly to the matrix rear IR receiver extension sockets. 4.
Page 12
The IR emitter use low power infrared diode as emitter so that it will not interface other infrared signal. Please stick the IR emitter near to the IR window of the STB or DVD. 5. IR receiver cable extender jacks. When the display device is not near to the matrix, the IR_RX cable will be to short.
Page 13
6. DIP switch for EDID setting. (Factory default setting: DIP in ‘000’ mode, EDID are all 1080P stereo). Position1 Position2 Position3 Function Enable EDID manual mix, mix result is compatible with all HDMI sinks that choose the same source (Note1) Enable EDID manual copy (Note2) 1080P stereo (Using Embedded EDID) (Note3)
Page 14
This setting can be used when the TV set is an old model that can not support 1080P. Note5: The matrix will use the embedded 1080P-5.1 EDID when the DIP switch is in this mode. The EDID will be 1080P video and 5.1 audio. ...
Page 15
Below is the diagram for the some usage example. 11 | P a g e...