Preparation; Operation - Fujitsu AUT36A Operating Manual

PREPARATION

Set the Current Time and Day
1
Press the CLOCK ADJUST button for more than three
seconds.
2 Press the SET TEMP./DAY button and set the day.
▲: Use to advance the day forward.
▼: Use to turn the day back.
The day is indicated by a code number from 1 to 7, as shown in the table
below. Set to the number that corresponds to the current day.
DAY CODE
DAY OF THE WEEK
3 Press the SET TIME button and set the time.
▲: Use to advance the time forward.
▼: Use to turn the time back.
(Press once to move the time 1 minute; hold down and the time will move
10 minutes at a time.)
4 Press the CLOCK ADJUST button again.
This registers the new day and time values. The day display goes off, and
the time display stops flashing.

OPERATION

Instructions relating to heating(*) are applicable only to "HEAT & COOL MODEL" (Reverse Cycle).
To Select Mode Operation
1 Press the START/STOP button.
The unit will start and the remote controller's operation lamp (green) will
light up.
2 Press the MASTER CONTROL button to select the de-
sired mode.
AUTO
c
COOL
To Set the Thermostat
Press the SET TEMP./DAY button to the desired temperature.
▲ : Press to raise the thermostat setting.
▼ : Press to lower the thermostat setting.
●Thermostat setting range:
AUTO .................................. 18 °C to 30 °C
* Heating ............................... 16 °C to 30 °C
Cooling ............................... 18 °C to 30 °C
The thermostat cannot be used to set room temperature during the FAN mode
(the temperature will not appear on the remote controller's display).
The thermostat setting should be considered a standard value, and may
differ somewhat from the actual room temperature.
4
1 2 3
MON TUE WED
*HEAT
c
FAN
d
d
4 5 6 7
THU FRI SAT SUN
CLOCK
DAY
1 2
TIMER SET TIME TEMP./DAY
MODE CONTROL
CLOCK ADJUST
ZONE ENERGY SAVE
2
3
1
SET DAY OFF
CLOCK
1 2
Example: Set the time to 9:31.
CLOCK TEMP
NON STOP AUTO
°C
HIGH
1 2
TIMER SET TIME TEMP./DAY FAN
MODE CONTROL
CLOCK ADJUST
ZONE ENERGY SAVE
SET DAY OFF
Example: When set to AUTO
NON STOP CLOCK TEMP AUTO
°C
HIGH
1 2
TIMER SET TIME TEMP./DAY FAN
MODE CONTROL
CLOCK ADJUST
ZONE ENERGY SAVE
SET DAY OFF
Example: When set to 26 °C
AUTO AUTO
DEFROST TEST
FAN
MASTER
CONTROL
START/STOP
AUTO
DEFROST TEST
MASTER
CONTROL
2
START/STOP
1
AUTO
DEFROST TEST
MASTER
CONTROL
START/STOP