Table of Contents
Advertisement
PREPARATION
Turn on the Power
1
Turn on the circuit breaker.
Load Batteries (AAA/R03/LR03 × 2)
1
Press and slide the battery compartment lid on the
reverse side to open it.
Slide in the direction of the arrow while pressing the
2
Insert batteries.
Be sure to align the battery polarities (
3
Close the battery compartment lid.
Set the Current Time
1
Press the CLOCK ADJUST button.
Use the tip of a ball-point pen or other small object to press the button.
2
Use the TIMER SET (
clock to the current time.
button: Press to advance the time.
button: Press to reverse the time.
(Each time the buttons are pressed, the time will be advanced/reversed in
1-minute increments; hold the buttons depressed to change the time quickly
in 10-minute increments.)
3
Press the CLOCK ADJUST button again.
This completes the time setting and starts the clock.
To Use the Remote Controller
The remote controller must be pointed at signal receiver to operate correctly.
l
Operating range: About 7 meters.
l
When a signal is properly received by the air conditioner, a beeping sound will be
l
heard.
If no beep is heard, press the button of the remote controller again.
l
Remote Controller Holder
Press in
Screws
1 Mount the holder.
2 Set the remote controller.
En-6
) correctly.
/
) buttons to adjust the
Insert
mark.
Slide up
Pull out
3 To remove the remote
controller (when use at
hand).
CAUTION
Take care to prevent infants from accidentally
l
swallowing batteries.
When not using the remote controller for an
l
extended period, remove the batteries to
avoid possible leakage and damage to the
unit.
If leaking battery fluid comes in contact
l
with your skin, eyes, or mouth, imme-
diately wash with copious amounts of
water, and consult your physician.
D e a d b a t t e r i e s s h o u l d b e r e m o v e d
l
immediately and disposed of properly, either
in a battery collection receptacle or to the
appropriate authority.
Do not attem pt to recharge dry batteries.
l
Never mix new and used batteries, or
batteries of different types.
Batteries should last about 1 year under
normal use. If the operating range of the
remote controller becomes appreciably
r e d u c e d , r e p l a c e t h e b a t t e r i e s a n d
press the RESET button with the tip of a
ballpoint pen or other small object.
Advertisement
Table of Contents
