Connecting The Supplied Power Cable - Yamaha A-S700 Owner's Manual

CONNECTIONS
To the wall outlet with the
supplied power cable
(Asia and General models)
• VOLTAGE SELECTOR
(Asia and General models only)
The VOLTAGE SELECTOR on the rear panel ofthis unit
must be set for your local main voltage BEFORE plugging
the supplied power cable into the wall outlet.
Improper setting of the VOLTAGE SELECTOR may
cause damage to this unit and create a potential fire
hazard.
Rotate the VOLTAGE SELECTOR clockwise or
counterclockwise to the correct position using a straight
slot screwdriver.
Voltages are as follows:
Asia modeL AC 2201230-240 V, 50/60 Hz
General model AC 110/120/220/230-240 V, 50/60 Hz
• AC OUTLET(S) (SWITCHED)
U.K. and Australia models I outlet
Korea model None
Other models 2 outlets
Use these outlets to connect the power cables from your
other components to this unit. The power to the AC
OUTLET(S) is controlled by POWER on the front panel
of this unit (or on the remote control). The outlet(s) supply
power to any connected component whenever the power
of this unit is turned on. For information on the maximum
power (total power consumption of components), see
"SPECIFICATIONS" on page 15.
Do not connect components with a built-in amplifier, such as a
subwoofer, etc.
• Connecting the supplied power cable
Plug the supplied power cable into the AC IN on the rear
panel of this unit and then, plug the power cable into the
wall outlet after all other connections are complete.
8
En