Digital Smart Zoom; Face Tracking - Digitus HD NETWORK SURVEILLANCE CAMERA User Manual

Table of Contents

To schedule the white LED to be enabled, go to "LED Timer Configuration", select "Yes" in "Enable",

and set the time to enable the LED. Each square equals 30 minutes.

4.7.7 Digital Smart Zoom

Column

Description

Smart Zoom

To switch this function on or off, select "Enable" or "Disable".

Or, it's also available to click

Detection

Select to set a specific detection area for this function.

Sensitivity

Select the digital smart zoom sensitivity (HIGH / MEDIUM / LOW)

Stand-by Interval

Select the stand-by interval (Short / Normal / Long).

Configure the parameters for face tracking.

Note: Face tracking is not supported when the stream format is set to Multi-Mode, and

will not be shown in the configuration page.

Function

Description

Face Tracking

Select "Enable" to activate or "Disable" to deactivate this function.

OSD

Select "ON" to display the following status messages on the live view:

FACE STANDBY:

FACE TRACKING:

FACE ZOOM IN / OUT: This function is zooming on the face for tracking / zooming out when the tracking

Sensitivity

Set the tracking sensitivity from HIGH / MEDIUM / LOW.

Resolution

Set the resolution for face tracking from Auto / VGA / QVGA.

to enable / disable this function on the live view panel.

This function is activated and ready to use.

This function is detecting.

object leaves the surveillance area.

Table of Contents