Table of Contents
Advertisement
Manual Channel Scan
In manual search the number of the multiplex is
entered manually and only that multiplex is searched
for the channels. In manual and auto search, any
existing channel in the database is not re-stored to
avoid redundant duplicates of that channel. To start
the scan enter the channel number manually and
press OK.
First Time Installation
Use this option to load default settings, which had
been set at the factory. To install factory settings,
highlight 'First Time Installation' menu and press OK
key, then you will be asked to confi rm deleting all
channels and settings. Selecting YES and pressing
OK will delete the channel table. Selecting "NO" and
pressing OK will cancel the operation.
Message
When the box receives no signal (e.g. the antenna
(cable is disconnected), "NO
SIGNAL" message is seen on the
screen.
When there are no channels stored in the box;
he Channel List menu is not accessible. Channel
navigation is not allowed. Therefore, trying to enter
these menus or navigate the channels will display an
error message on the screen.
Specifi c Functions of Remote Control
When there is no menu active on the screen, each
of the keys have specifi c functions.
OK KEY: when OK key is pressed Channel list
appears on the screen.
RECORD KEY
The programs are recorded at once.
• Record time is attained from EPG automatically. If
the program has EPG information, you could set the
timer. If there is no EPG info, press the Record button
to set the timer in 30 minutes periods.
• In EPG by pressing the record key, programs are
recorded instantly.
LIB KEY : by pressing this key, you will get to the
Recordings Library, which shows you the details of
your saved recordings. By pressing it again, you will
exit the Recordings Library.
SUBTITLE : subtitle key shows/hides subtitles of
channel. When the subtitle key is pressed,subtitle
ON/OFF message is displayed.
INFO KEY
When INFO key pressed, and when changing channels
the information window is displayed on the lower part of
the screen. The small bar indicates the program duration.
On the channel info window there are
• Current event name next event name, and their start
and end times.
• Program duration bar
• Program mode (TV or Radio)
• Channel number
• Name of the channel
PR+ / PR – (CHANNEL NAVIGATION )
There are two ways to navigate through the
channels:
• Pressing PR +/ PR - keys will take you to go to the
next or the previous channel in the list.
• Pressing a number key will activate a small digit
entry window on the left upper corner of the screen.
After a digit is entered, the box will stay for 2 seconds
while you enter another digit. If no digit is entered
during these 2 seconds, then the box will switch to the
entered number channel.If a number that is greater
than the maximum number of channels is entered, the
box will switch automatically to the last channel.
• Press OK button to display the channel list.
Volume Control
The volume level of the sound from the receiver
can be altered with the VOL+ and VOL- keys on the
remote control handset. Pressing either key displays
a bar graph of the sound volume on the TV screen.
The volume level selected will remain set, even
when the receiver is turned off and on again, until
it is altered with VOL + and VOL - keys.The audio
volume adjustment for the receiver is independent of
the volume control on your TV set. Be careful that both
volume controls are kept within reasonable levels so
that when switching from analogue to digital television
viewing, or when fi rst turning on your TV set, the sound
level is not too high.
You can silence the sound from the receiver by
pressing the MUTE key. The sound remains
muted until the MUTE key is pressed again, the VOL
+ or VOL- keys are pressed. While the sound is muted
in this way, the mute symbol is displayed in the top
left of the TV screen. The symbol is removed after 3
seconds, but the sound will remain muted until the
English - 19 -
Hide quick links:
Advertisement
Table of Contents
