Operating Environment - Pioneer CT-L11 Operating Instructions Manual

These labels can be found on the unit's rear
panel.
IMPORTANT
FOR USE IN THE
UNITED KINGDOM
The wires in this mains lead are
coloured in accordance with the
following code:
Blue :
Brown :
If the plug provided is unsuitable for
your socket outlets, the plug must be
cut off and a suitable plug fitted.
¶ When using this product follow the instructions written on the underside of the unit, which concern rated voltage, etc.
Thank you for buying this PIONEER product.
Please read through these operating instructions so you
will know how to operate your model properly. After you
have finished reading the instructions, put them away in
a safe place for future reference.
In some countries or regions, the shape of the power plug
and power outlet may sometimes differ from that shown
in the explanatory drawings. However, the method of
connecting and operating the unit is the same.
¶ This component cannot be operated alone; please use
in combination with the CD tuner XC-L11 or DVD/CD
tuner XV-DV77/DV88.
2
En
RISK OF ELECTRIC SHOCK
The cutoff plug should be disposed of and must
not be inserted into any 13 amp socket as this
can result in electric shock. The plug or adaptor
of the distribution panel should be provided
with a 5 amp fuse. As the colours of the wires
in the mains lead of this appliance may not
correspond with coloured markings identifying
the terminals in your plug, proceed as follows:
The wire which is coloured blue must be
Neutral
connected to the terminal which is marked with
Live the letter N or coloured black.
The wire which is coloured brown must be
connected to the terminal which is marked with
the letter L or coloured red.
Ces étiquettes se trouvent sur le fond de l'appareil.
CAUTION
DO NOT OPEN

Operating Environment

Operating environment temperature and humidity:
° °
+5 C – +35 C (+41
vents not blocked)
Do not install in the following locations
• Location exposed to direct sunlight or strong artificial
light
• Location exposed to high humidity, or poorly ventilated
location
VENTILATION:
sure to leave space around the unit for ventilation to
improve heat radiation (at least 30 cm at top, 15 cm at
rear, and 15 cm at each side).
WARNING:
provided for ventilation and to ensure reliable
operation of the product and to protect it from
overheating, to prevent fire hazard, the openings
should never be blocked and covered with items, such
as newspapers, table-cloths, curtains, etc. Also do not
put the apparatus on the thick carpet, bed, sofa, or
fabric having a thick pile.
ATTENTION
DANGER D'ELECTROCUTION
NE PAS OUVRIR
Do not connect either wire to the earth
terminal of a three-pin plug.
NOTE
After replacing or changing a fuse, the
fuse cover in the plug must be replaced
with a fuse cover which corresponds to
the colour of the insert in the base of the
plug or the word that is embossed on the
base of the plug, and the appliance must
not be used without a fuse cover. If lost,
replacement fuse covers can be obtained
from your dealer.
Only 5 A fuses approved by B.S.I. or
A.S.T.A. to B.S. 1362 should be used.
H045 En
° °
F – +95 F); less than 85%RH (cooling
When installing this unit, make
Slot and openings in the cabinet are
H040 En