The Digital Cd Clock Radio; Protection Against Main Power Failures; The Display; Setting Time - RCA RP3750 User Manual

THE DIGITAL CD CLOCK RADIO

Protection against main power failures:

1. Remove battery compartment door (located on the bottom of the radio) by
applying thumb pressure to area indicated on battery door and then lift the door
out and off the cabinet.
2. Connect a 9-volt battery connector plug. (6LR61 or NEDA 1604A)
3. Insert battery in the compartment and replace the compartment door.
NOTE: Alkaline (6LR61/NEDA 1604A) batteries are recommended. Carbon-zinc battery may be
used but memory holding time will be substantially reduced. Memory holding time for a
fresh alkaline battery is approximately 8 hours (if radio or alarm are not operated) which
should take care of short, nuisance-type AC power failures. To preserve battery life, the unit
should remain plugged into an AC outlet. As the battery gets older, its voltage drops and
memory may be lost. Be sure to replace the battery periodically. Battery should be removed if
the unit will be stored for more than one month. Leaky battery can badly damage the clock
radio.

The Display

AM/PM
indicator
Radio band
indicator
Wake 1 to
Tone / Radio / CD
Tip: Tip:
Tip: Tip: Tip:
Slide the DIMMER DIMMER DIMMER switch on the back of the unit between ON DIMMER
DIMMER
adjust the LED display brightness.
2
RP3750 EN 6-7
Radio frequency
scale
Nap Indicator
Wake 2 to
CD / Radio / Tone
ON and OFF ON ON OFF OFF to OFF
ON OFF
THE DIGITAL CD CLOCK RADIO
To set clock and wake time, slide the selector switch on the top
of the unit to select between setting LOCK, WK1, WK2 and
CLOCK.

Setting time

1
2
NOTE NOTE: NOTE NOTE NOTE
1. Press and hold TUNING/TIME DN TUNING/TIME DN TUNING/TIME DN TUNING/TIME DN TUNING/TIME DN or UP UP UP UP UP
2. The time display is in 12-hour format. AM/PM indicator will light to show AM
or PM time respectively.
You can choose to wake to Radio, CD or tone.

Setting Wake to Tone

1
2
2 3
Tip: Tip:
Tip: Tip: Tip:
GRADUWAKE GRADUWAKE
1. With the GRADUWAKE GRADUWAKE GRADUWAKE feature,
the alarm tone volume will increase
gradually to its maximum in about 30
to 45 seconds.
2. You cannot adjust the volume
level of the alarm tone.
3/11/02, 10:40 AM
EN
Slide the selector switch to CLOCK.
1
Press TUNING TIME DN or UP
2
to select current
time.
to skip fast
Slide the selector switch to select
1
WK1 or WK2.
If selector switch is set to WK1,
2
press WK1 to select wake
to tone .
Press WK2 if selector switch
is set to WK2 to select wake to
tone .
Press TUNING/TIME DN or UP
3
to set the wake time.
3