Description And Features; Connection And Operation - Samlexpower SEC-1212CE Installation & Operating Manual

DESCRIPTION
SEC-1212CE / SEC-1223CE are switched mode power supplies which con-
vert 230 VAC, 50 HZ to regulated 13.8 VDC based on pulse width modula-
tion ( PWM ) control.
FEATURES
∫
BASED ON SWITCHED MODE TECHNOLOGY AND PWM CONTROL
∫
COMPACT AND LIGHTWEIGHT
∫
HIGH EFFICIENCY AND LESS HEAT DISSIPATION
∫
PROTECTED AGAINST SHORT CIRCUIT, OVER CURRENT AND
OVER VOLTAGE (THROUGH PWM CONTROLLER)
∫
SEC-1212CE IS CONVECTION COOLED. SEC-1223CE HAS FORCED
AIR COOLING AND OVER TEMPERATURE SHUT DOWN
∫
CE MARKED
∫
COMPLIES WITH EUROPEAN EMISSION AND IMMUNITY STAN-
DARDS

CONNECTION AND OPERATION

NOTE! The DC output connector has a tubular hole of diameter 0.2" (5mm)
with a set screw. For a firm connection, crimp/solder a pin type copper termi-
nal on the cable ends of your 12V DC device.
Ensure that the power supply's ON/OFF switch is off and it is unplugged
from the AC outlet.. Switch off your 12 V DC device and connect it's positive
and negative to the RED ( Positive ) and WHITE ( Negative ) terminals re-
spectively. Ensure that the connections are secure and tight. Plug the power
supply into the AC outlet. Press the ON/Off switch of the power supply to ON
and observe that the neon indicator in the switch illuminates. If the indicator
fails to light , recheck the connection, AC outlet and the fuse inside the
power supply.
Your 12 V DC device may now be switched on.
2.