Marantz PM5005 Owner's Manual page 33

Contents Connections
Setting remote control codes for the
remote control
o To set the remote control codes to AMP2
1
Hold down REMOTE MODE CD and the number 2
button for more than 5 seconds.
o To set the remote control codes to AMP3
1
Hold down REMOTE MODE CD and the number 3
button for more than 5 seconds.
To return the remote control code to the default setting, hold down REMOTE MODE
CD and the number 1 button for more than 5 seconds.
NOTE
The remote control codes returns to the default settings when the batteries are
removed. Set the remote control codes again after replacing the batteries.
Front panel Rear panel
Playback
Setting remote control codes for this
unit
1
Remote control
33
unit
Settings Tips
Point the remote control for which the remote control
code was set at this unit, and press REMOTE MODE CD
and ENTER.
The input indicators on the unit flash as shown below according to
the set remote control code.
Remote control codes
AMP 1 PHONO indicator flashes three times
AMP 2 TUNER indicator flashes three times
AMP 3
Index
Appendix
Input indicator
CD indicator flashes three times