Direct Ignition Wiring Diagram; Optional Remote Control - Empire Comfort Systems DVP36FP3 Installation Instructions And Owner's Manual

Steady ON
2 Flashes
3 Flashes
4 Flashes
Steady Flash
Electric (120 volt) Operated Remote Control (FREC)
1. Disconnect 3-prong power cord from receptacle.
2. Remove wire from 120 VAC hot terminal on control module.
3. Connect female terminal from receiver onto 120 VAC hot
terminal on control module.
4. Connect remaining wire from remote control (male
terminal) to (female terminal) on power cord removed from
control module (step 2).
Page 50

DIRECT IGNITION WIRING DIAGRAM

Normal operation, power ON to control
3 unsuccessful ignition trials
Main burner flame failed 4 times during a single heating cycle
Interrupt power for 5 seconds to reset control
Flame detected out of sequence

OPTIONAL REMOTE CONTROL

LED CODES
Figure 71
5. Insert electric remote control power cord plug into the
junction box on the right side of fireplace.
6. Connect 3-prong plug into receptacle.
31447-5-0214