Download Print this page

Special Salt; Using Special Salt; Detergents With Salt Component; Switching Off Water Softening System - Siemens Dishwasher Operating Instructions Manual

Hide thumbs


Special salt $

Using special salt

Always refill with special salt immediately
before switching on the appliance. This
ensures that overrun special salt solution
is immediately washed out and does not
corrode the rinsing tank.
– Open the screw-type cap of the
compartment 1J.
– Fill the tank with water (only required
when switching on the appliance for
the first time).
– Then add dishwasher salt (not table
salt or tablets).
The water is displaced and runs out.
As soon as the salt refill indicator )* on
the fascia is lit, top up the salt.
* depending on model
Using detergents with salt
D e t e r g e n t s w i t h s a l t c o m p o n e n t
If combined detergents with a salt
component are used, salt can usually be
omitted up to a water hardness of 21° dH
(37° fH, 26° Clarke, 3.7 mmol/l). If the
water hardness is over 21° dH, special
salt must be used.
S witching off salt refill indicator/
S w i t c h i n g o f f w a t e r s o f t e n i n g s y s t e m
water softening system
If the salt refill indicator )* is impaired
(e.g. when using combined detergents
containing salt component), it can be
switched off.
– Proceed as described under "Adjusting
Never fill the salt dispenser with detergent.
You will destroy the water softening
the water softening system" and select
setting 0.
The water softening system and salt
refill indicator are now switched off.



This manual is also suitable for: