Playback; Selecting A Component - Sony STR-DH500 Operating Instructions Manual

Playback
Selecting a component
MASTER
VOL +1-
Input
buttons
-+--it--
MUTING
continued---
AMP
(-~I--
MENU
BO
JY!Z
SAT
8.~ 8
TV SA-COICO TUNER
888
+1+1..1+,
CD
1
Press the input button to select
a component.
You can also use INPUT SELECTOR on
the receiver.
The selected input appears on the display.
The test tone is output from each speaker
in sequence as follows:
Front left -. Center -. Front right -.
Surround right -. Surround left - .
Subwoofer
You can also press any input buttons.
The test tone turns off.
When a test tone is not output
from the speakers
• The speaker cords may not be connected
securely.
• The speaker cords may have the short-circuit
problem.
Note
The test tone does not work when ANALOG
DIRECT is selected.
7
Repeat steps 1 to 5 to select
"T. TONE N".
6
Adjust the speaker levels and
balance using the LEVEL menu
so that the level of the test tone
sounds the same from each
speaker.
For details, see "Adjusting the level
(LEVEL menu)" (page 32).
Tips
• To adjust the level of all speakers at the same
time, press MASTER VOL
+/-.
You can also
use MASTER VOLUME on the receiver.
• The adjusted value is shown on the display
during adjustment.
5
Press
+'+
repeatedly to select
"T. TONE V".