Pioneer DEH-P6800MP Operation Manual page 57

C
A_u_d_io_A_dJ_·u_st_m_e_n_t_s )
Section
(
~)GI
1 Recall the equalizer curve you want to
adjust.
See
Recalling equalizer curves
on the previous
page.
2 Use MULTI-CONTROL to select 7-band
graphic equalizer adjustment.
Frequency and the level (e.g.,
50Hz +4)
ap-
pears in the display.
3 Push
MULTI-CONTROL
left
or right to
select the equalizer band to adjust.
Each pushing MULTI-CONTROL left or right
selects equalizer bands in the following order:
5Q-12S-31S-80Q-2k-Sk-12.Sk
(Hz)
4
Push MULTI-CONTROL up or down to
adjust the level of the equalizer band.
Each pushing
MULTI-CONTROL
up or down
increases or decreases the level of the equali-
zation band.
+6 - -6
is displayed as the level is increased
or decreased.
• You can then select another band and adjust
the level.
5 Press BAND to cancel the 7-band gra-
phic equalizer adjustment. [!J
Adjusting loudness
Loudness compensates for deficiencies in the
low- and high-sound ranges at low volume.
1 Use MULTI-CONTROL to select LOUD.
LOUD
appears in the display.
2 Press MULTI-CONTROL to turn loudness
on.
Loudness level (e.g.,
Mid)
appears in the dis-
play.
• To turn loudness off, press MULTI-CONTROL
again.
3 Push
MULTI-CONTROL
left
or right to
select a desired level.
Each ti me
MULTI-CONTROL
is pushed left or
right, level is selected in the following order:
Low
(Iow)-Mid (mid)-High (high) [!J
Using subwoofer output
This unit is equipped with a subwoofer output
which can be turned on or off.
1
Use MULTI-CONTROL to select Sub
W.1.
Sub W.1
appears in the display.
• You can also select the subwoofer setting
menu by pressing
SW
on the unit.
2 Press MULTI-CONTROL to turn subwoo-
fer output on.
Normal
appears in the display. Subwoofer out-
put is now on.
• To turn subwoofer output off, press
MULTI-CONTROL again.
3 Push MULTI-CONTROL left or right to
select the phase of subwoofer output.
Push MULTI-CONTROL left to select reverse
phase and
Reverse
appears in the display.
Push
MULTI-CONTROL
right to select normal
phase and
Normal
appears in the display.
Adjusting subwoofer settings
When the subwoofer output is on, you can ad-
just the cut-off frequency and the output level
of the subwoofer.
1 Use MULTI-CONTROL to select Sub W.2.
Sub W.2
appears in the display.
• You can also select the subwoofer setting
menu by pressing SW on the unit.
• When the subwoofer output is on, you can se-
lect
Sub
W.2.
En
CID