Pioneer operation manual cd rds receiver deh-p6000ub (120 pages)
Summary of Contents for Pioneer DEH-P6800MP
DEH-P6800MP This product conforms to CEMA cord colors. Le code de couleur des câbles utilisé pour ce produit est conforme à CEMA. Printed in Thailand Imprimé en Thaïlande <XRD7112-A/N> UC <KMMZX> <05H00000>...
Connecting the Units Note: • This unit is for vehicles with a 12-volt battery and negative grounding. Before installing it in a recre- ational vehicle, truck, or bus, check the battery voltage. • To avoid shorts in the electrical system, be sure to disconnect the ≠...
When not connecting a rear speaker lead to a Subwoofer Antenna jack 15 cm (5-7/8 in.) This product Subwoofer output Jack for the Wired Remote Control Please see the Instruction Manual for the Wired Remote Control (sold separately). Yellow/black If you use an equipment with Mute function, wire this lead to the Audio Mute lead on that equipment.
Connecting the Units When using a Subwoofer without using the optional amplifier Antenna jack 15 cm (5-7/8 in.) This product Subwoofer output Jack for the Wired Remote Control Please see the Instruction Manual for the Wired Remote Control (sold separately). Yellow/black If you use an equipment with Mute function, wire this lead to the Audio Mute lead on that equipment.
Note: • Before making a final installation of the unit, tem- porarily connect the wiring to confirm that the con- nections are correct and the system works properly. • Use only the parts included with the unit to ensure proper installation. The use of unauthorized parts can cause malfunctions.
Removing the unit (Fig. 6) (Fig. 7) Frame To remove the frame, extend top and bottom of the frame outwards in order to unlock it. (When reattaching the frame, point the side with a groove downwards and attach it.) • It becomes easy to remove the frame if the front panel is released.
DIN Rear-mount Installation using the screw holes on the side of the unit 1. Remove the frame. (Fig. 8) 2. Fastening the unit to the factory radio mounting bracket. (Fig. 9) (Fig. 10) Select a position where the screw holes of the bracket and the screw holes of the head unit become aligned (are fitted), and tighten the screws at 2 places on each side.