Preparation; Attaching The Stand; Angle Adjustment - Sharp LC-40LX710H Operation Manual

Preparation

Attaching the stand

• Only applicable to 52", 46" and 40" models.
• Before attaching (or detaching) the stand, unplug the AC cord from the AC INPUT terminal.
• Before performing work spread cushioning over the base area to lay the TV on. This will prevent it from being damaged.
CAUTION
• Attach the stand in the correct direction.
• Be sure to follow the instructions. Incorrect installation of the stand may result in the TV falling over.
Confi rm the 4 screws supplied with the TV.
1
Screws ( g 4)
(used in step 3)
Set up the stand, and then adjust the TV to fi t
2
in the stand and set the TV.
• When lifting the TV, do not grasp the LCD panel; the correct
way is to hold the bottom with one hand and hold the top
with the other, preventing hitting the TV during the lifting.
To fasten and set up here
Affi x the TV to the stand.
3
Attach the 4 short screws into the 4 holes on
the rear of the TV.
NOTE
• When attaching the stand with the TV laying fl at, spread a soft
cushion on the table and lay the TV on it.
• To detach the stand, perform the steps in reverse order.
40LX710H_en.indd 7 40LX710H_en.indd 7

Angle adjustment

You can rotate up to 20 degrees to the right or left.
• Adjust the screen with both hands. Place one hand on the
• Angle adjustment is not available with the LC-60LX710H.
If the position of the stands
is not wide enough, please
set up from the behind.
The position of
setting up the stand
Screwdriver
Screw hole
20°
Front
CAUTION
TV and rotate the screen while holding the bottom of the
stand (the black part in the above illustration) with your
other hand.
20°
7
2010/04/15 16:11:07 2010/04/15 16:11:07