Table of Contents
Advertisement
RFSDV22/32/42 Freestanding Direct Vent Fireplace
SR5
SR2
Burner Lava Rock
Placement
Fig. 33 RFSDV42 log and burner lava rock placement.
Ceramic Refractory
RFSDV42 ONLY
1. Remove bay window assembly and glass frame (see
"Glass frame Removal" section).
2. Remove logs from the unit.
Logs may be hot!
3. Remove refractory from packaging.
Refractory are fragile and must be han-
dled with care. Where at all possible, two
hands should be used when handling.
4. Place center refractory piece at the very back of the
firebox.
5. Slide left or right side refractory along the side of the
firebox and on top of the bottom support channel. Be
sure to slide the panel back to hold the center piece
in place and the leading edge faces forward.
6. Fasten top tab support against the refractory to hold
it in place.
7. Repeat steps 5 and 6 for remaining side refactory.
8. Insert refractory pieces into the Bay Window as
shown in Figure 35.
Leading Edge
Left Side
Fig. 34 Ceramic panels.
18
SR6
SR4
Leading Edge
Center
Right Side
SR3
SR1
Fig. 35 Bay window ceramic refractory.
LG281
Flame Adjustment (RN/RP Models)
For units equipped with Hi/Lo valves, flame adjustment
is accomplished by rotating the Hi/Lo adjustment knob
located near the centre of the gas control. (Fig. 36 &
37)
Turn
counterclockwise
to decrease
flame height
Fig. 36 Flame adjustment knob for Honeywell valve.
Turn
counterclockwise
to increase
flame height
Fig. 37 Flame adjustment knob for SIT valve.
Temperature Adjustment (TN/TP Models)
The Hi/Lo reference on the control knob (Fig. 38) is to
indicate a higher or lower temperature setting. This
setting controls the heat by reducing then shutting off
the flame as the desired temperature is reached.
Position the control knob where it effectively maintains
a comfortable room temperature.
FP1348
Fig. 38 Temperature adjustment knob for TN/TP models.
FP1349
Turn clockwise
to increase
flame height
Turn clockwise
to decrease
flame height
10001028
Hide quick links:
Advertisement
Table of Contents
