Panasonic DP-80116P Operating Instructions Manual page 56

Function
■ General Settings (For Key Operator) (Continued)
No.
DNS SERVER ADDR. ∗
23
24 MAC ADDRESS
HARD DISK FORMAT ∗
25
HARD DISK ERR CHK ∗
26
27 ABBR GROUP ID
COMMUNITY NAME(1) ∗
28
COMMUNITY NAME(2) ∗
29
DEVICE NAME ∗
30
DEVICE LOCATION ∗
31
33 USER AUTH
34 AUTH DOMAIN
∗
NOTE 4 Available only when the optional Hard Disk Drive Unit is installed.
∗
5 When Parameters No. 28 to 31 are set, cycle the power by turning the Power Switch on the Right Side of the
machine OFF and ON.
56
Modes
2
Selects whether to enable the DNS Server, and 2:VALID
sets its settings for Internet Fax/Email Function.
1:INVALID
2:VALID
<Sub-Function>
1:HOST NAME / 2:DOMAIN NAME /
3:PRI. DNS SERVER (IP ADDRESS1) /
4:SEC. DNS SERVER (IP ADDRESS2)
Indicates the MAC address.
4
Formats the hard disk.
PRESS SET TO START
4
Selects the provision for the hard disk error check.
PRESS SET TO START
Inputs the Group ID for the address book.
0-99
5
Selects whether to change the Community
Name(1) SNMP.
Enable read only
5
Selects whether to change the Community
Name(2) SNMP.
Enable read/write
5
Inputs the device name when required.
(For Status Monitor/EtherTalk Machine Name)
5
Inputs the device location when required.
(For Status Monitor)
Set the User Authentication Mode.
COPY
1:INVALID / 2:VALID
FAX
1:INVALID / 2:VALID
PRINTER
1:INVALID / 2:VALID
SCANNER
1:INVALID / 2:VALID
Inputs the Authentication Domain Name
Domain Name: Up to 15 characters.
DNS Domain Name: Up to 60 characters.
Function
Initial
Setting
0
public
public
INVALID
INVALID
INVALID
INVALID