Table of Contents
Advertisement
INSTALLATION
WA R N I N G : M a i n t a i n t h e
minimum clearances
i n
F i g u r e 4 . I f y o u c a n ,
provide greater clearances from
floor, ceiling, and joining wall.
Figure 4 -Mounting Clearances
As Viewed From Front Of Heater
FASTENING HEATER TO WALL
Mounting Bracket
The mounting bracket is located
on
back panel of heater (see
Figure 5). It has been taped there
for shipping. Remove mounting
bracket from back panel.
Figure 5 -Mounting Bracket
Location
Removing Lower Front Panel Of
Heater
shown
1. Remove two screws near
bottom corners of lower front
panel.
2. Pull bottom of lower front panel
forward, then down (see Figure
6).
Figure 6 - Removing Lower Front
Panel Of Heater
Methods For Attaching Mounting
Bracket To Wall
Only use last hole on each end
of mounting bracket to attach
bracket
to wall. Attach mounting
bracket to wall only in one of two ways:
1.
Attaching to wall stud
2.
Attaching to wall anchor
Attaching to Wall Stud: This method
provides the strongest hold. Insert
mounting screws through mount-
ing bracket and into wall studs.
Attaching to Wall Anchor: This
method
mounting bracket to hollow walls
(wall areas between studs) or to
solid walls (concrete or masonry).
Decide
suits your needs. Either method
will provide a secure hold for the
mounting bracket.
Marking Screw Locations
1. Tape mounting bracket to wall
where heater will be located.
Make sure mounting bracket is
level.
minimum
Figure 8. If you can, provide
greater
and joining wall.
2.
wall. (see Figure 7)
Note: Only mark last hole on
each end of mounting bracket.
Insert mounting screws through
these holes only.
3.
bracket from wall.
7
allows
you
which
method
WARNING:
clearances shown in
clearances
from
Mark
screw
locations
Remove tape and mounting
Figure 7 - Mounting Bracket
Clearances
to attach
better
Maintain
floor
on
Advertisement
Table of Contents
