Roland R-09HR Owner's Manual page 123

Malfunction
• Malfunctions can be avoided by setting the Remote Control to "Disable."
The settings disappear
• If all the settings in the <Menu Screen> are restored to factory defaults, the R-09HR may have
been accidentally reset to factory defaults. Please reconfigure the settings.
"Initializing the R-09HR (Factory Reset)" (p. 116)
The R-09HR is connected to the PC with a USB cable, but the PC doesn't
recognize it
• The PC will not recognize the R-09HR if the connection is made while the <Menu Screen> is
showing or during playback or recording. First, disconnect the USB cable connecting the R-
09HR to the PC, and then try again.
"Connecting to the PC" (p. 67)
Displaying the song name is slow when selecting a song
• This problem may be caused by a corrupted song, illegal song format, unsupported MP3
format, a song that is too large, or a song with an .MP3 or .WAV extension that is taking
time to verify on the R-09HR as playable.
These conditions cause the display to be sluggish when selecting a song.
"Song types that can be played" (p. 66)
Feedback occurs when monitoring with headphones
• If open air headphones are used to monitor recording, feedback may occur if the
headphones are too close to the R-09HR. The R-09HR's internal microphones are capable of
picking up even the faintest of sounds, so do not move too close to the R-09HR.
The internal clock resets
• When the power is on, the internal clock draws power from the AC adaptor or the batteries.
When the power is off, the internal clock will run temporarily on the power stored in the main
unit. However, if the power is off for several days, the internal clock settings return to the
original settings (initial status). When power is turned on in initial status, the message "Clock
Initialized" is shown.
If "Clock Initialized" is shown, please reset the date and time.
"Setting the date and time (Date & Time)" (p. 109)
Troubleshooting
123