Setting The Low Cut Frequency - Roland R-09HR Owner's Manual

Setting the low cut frequency (Low Cut Freq)
This sets the frequency to apply Low Cut when the [Low Cut Switch] is on.
fig.inputsetting-e.eps_80
1.
Select "Input Setup" from the [Menu
Screen].
Use the [PLAY Button
"Input Setup," and then press the [REC Button].
fig.limiterAGC-e.eps_80
2.
Select "Low Cut Freq."
Use the [PLAY Button
the cursor to the Low Cut Freq line.
fig.setlimiterAGC-e.eps_80
3.
Set the Low Cut Freq frequency.
Use the [PREV Button
the Low Cut value.
Setting
When finished with the settings, press the [MENU button] to return
to the previous screens, in order.
] and [STOP Button
] and [STOP Button
] and [NEXT Button
100 Hz
200Hz
400Hz
R-09HR configuration settings
] to select
Move the
cursor
up or down
] to move
Move the
cursor
up or down
] to change
Change
the value
Enter
107