Table of Contents
Advertisement
16
DX-24E310NA15
Connecting an antenna or cable TV (no box)
On your TV
Coaxial cable
connector
ANT/CABLE IN
jack
1 Make sure that your TV's power adapter is unplugged and all connected equipment is turned off.
2 Connect a coaxial cable (not provided) to the ANT/CABLE IN jack on the side of your TV and to the antenna or cable TV
wall jack.
3 Plug your TV's power adapter into a power outlet, then turn on your TV.
4 Press INPUT to open the INPUT SOURCE list.
5 Press
or
6 If you cannot tune to channels you know exist, scan for channels. See
to highlight TV, then press ENTER.
Notes
• Use a coaxial cable to eliminate interference and noise from
radio waves.
• Do not bundle the coaxial cable with the power adapter or
other cables.
• If the antenna is not installed correctly, contact qualified service
personnel to correct the problem.
• If the signal level for a channel is weak, the picture may be
distorted. Adjust the antenna or use a highly directional
outdoor or set-top antenna with a built-in amplifier.
• If the picture quality is good on some channels and poor on
others, the problem may be caused by a poor or weak signal
from the broadcaster or cable TV provider.
• If you connect to cable or satellite TV without a set-top box and
experience poor picture quality, you may need to install a
set-top box to improve signal reception and picture quality.
Contact your cable or satellite TV provider about upgrading to
a set-top box.
• Many high-definition (HD) channels upscale
standard-definition (SD) content. The picture displayed on your
TV is still displayed as SD, thus the picture quality will not be as
clear or crisp as it would be if the content was originally
recorded in HD.
Antenna or
cable TV
(no box)
Coaxial cable
Side of TV
"Automatically scanning for
www.dynexproducts.com
Dynex 24" LED TV
channels" on page 49.
Advertisement
Table of Contents
