Vivotek IP8371E Quick Installation Manual
Bullet network camera
Hide thumbs
Also See for IP8371E:
- User manual (203 pages) ,
- Quick installation manual (11 pages) ,
- Quick start manual (11 pages)
Table of Contents
Advertisement
Quick Links
Download this manual
See also:
User Manual
Advertisement
Table of Contents
Related Manuals for Vivotek IP8371E
Summary of Contents for Vivotek IP8371E
-
Page 2: Package Contents
Do not insert sharp or tiny objects into the Network Camera. Package Contents Sun Shield / Wrench / RJ45 Female / IP8371E with an RJ45 Cable Female Coupler / Double-sided Tape / Screws Waterproof Connector for RJ45 Wall Mount Bracket... -
Page 3: Warranty Card
Quick Installation Guide Software CD IP8371E Network Bullet Camera Quick Installation Guide Français Deutsch Italiano Türkçe Polski Русский Česky Svenska English 繁中 簡中 日本語 Español Português 2MP • Outdoor • Day & Night Cable Management Warranty Card Physical Description Lens... -
Page 4: Hardware Installation
Hardware Installation 1. Attach the alignment sticker to the wall. Drill four holes into the wall. Then hammer the supplied plastic anchors into the holes and secure the plate with supplied screws. 2. Fix the intersection bracket to the side of the Network Camera with two screws. 3. -
Page 5: Cabling Assembly
Cabling Assembly Waterproof Connector Components of the Waterproof Connector IMPORTANT: Screw Nut (A) If you should need to open the front cover, make Seal (B) sure you tighten it up later so that the camera can Seals (C) be waterproof. Housing (D) Sealing Nut (E) Pin Definitions... - Page 6 Assembling Steps 1. Disassemble the components of the waterproof connector into part (A) ~ (E) as shown above. 2. Open the rear cover of the Network Camera. 3. Remove the rubber stopper from the bottom of the Network Camera and secure the screw nut (A) tightly.
-
Page 7: Rj45 Cable Connector
RJ45 Cable Connector RJ45 Cable Dimension (unit: mm) Components of the Waterproof Connector Sealing Nut (A) Seal (B) Screw Nut (C) Housing (D) Gasket (E) Assembling Steps Insert the seal into the housing. Insert the housing into the Prepare an Ethernet cable screw nut. -
Page 8: Network Deployment
Network Deployment Power over Ethernet (PoE) When using a PoE-enabled switch The Network Camera is PoE-compliant, allowing transmission of power and data via a single Ethernet cable. Follow the below illustration to connect the Network Camera to a PoE-enabled switch via Ethernet cable. PoE Switch When using a non-PoE switch Use a PoE power injector (optional) to connect between the Network Camera and a non-PoE... -
Page 9: Assigning An Ip Address
2. The program will conduct an analysis of your network environment. After your network is analyzed, please click on the "Next" button to continue the program. 3. The program will search for VIVOTEK Video Receivers, Video Servers, and Network Cameras on the same LAN. - Page 10 2. Attach the supplied sun shield to the Network Camera and slide it to the desired position. 3. Fix the sun shield with the supplied two screws. Accessories VIVOTEK also provides other accessories for versatile applications as the following illustrations. Please visit VIVOTEK's official website for more purchase information. Corner Mount Bracket...