Fanimation Old Havana Series Owner's Manual page 6

How to Assemble the Ceiling Accessory (cont'd)
10. Remove the ¼˝ rod and thread the third ¼-20 x 1½˝
allen head bolt into this hole.
11. Tighten the 3 allen head bolts.
12. Pass the Downrod / Hanger Ball Assembly through
the top of the ceiling canopy and push the bell shaped
motor coupling cover onto the downrod as shown.
NOTE: You will be using either the 6˝ downrod sup-
plied with your fan or an optional downrod purchased
separately.
13. Separate and untwist the three motor leads. Route
the motor leads through the Downrod/Hanger Ball As-
sembly.
WARNING
It is critical that the clevis pin in the downrod support
is properly installed and the setscrews are securely
tightened. Failure to verify that the pin and setscrews
are properly installed could result in the fan falling.
14. Loosen the two setscrews in the downrod support.
Align the clevis pin holes in the downrod with the holes in
the downrod support. Install the clevis pin and secure with
the hairpin clip (Fig. 5). The clevis pin must go through
the holes in the downrod support and the holes in the
downrod. Be sure to push the straight leg of the hairpin
clip through the hole near the end of the clevis pin until the
curved portion of the hairpin clip snaps around the clevis
pin. The hairpin clip must be properly installed to prevent
the clevis pin from working loose. Pull on the hanger ball
to make sure the clevis pin is properly installed.
15. While pulling up on the hanger ball, securely tighten
the two 3/16-24 x 3/8˝ setscrews in the downrod sup-
port (Fig. 5).
NOTE: The setscrews must be prop erly in stalled as
described above, or fan-wobble will result.
Green
(Ground)
White
Green
Black
Clevis Pin
Setscrew (2)
16. The fan comes with green, black, and white leads.
Before installing fan, measure up approximately 6-9
inches above top of Downrod/Hanger Ball Assembly.
Cut off excess wire and strip back insulation ½" from
end of wire.
17. You have now completed the assembly of your ceiling
fan. You can now proceed with the hanging and the
electrical wiring of your fan.
WARNING
To reduce the risk of personal injury, do not insert
foreign objects in between the rotating blades.
4
Ceiling
Canopy
Downrod
/Hanger Ball
Assembly
Motor Cou pling
Cover
Hairpin Clip
Motor
Assembly
Fig. 5