Antenna And Powerconnect Power - Sirius XM RAdio Onyx Plus User Manual

Vehicle Installation
logos. Be careful not to crimp or cut the cable.
5. Bring the cable out from the trim near the front of the cabin and route
it under the carpet toward the dashboard or console. Coil any excess
cable in a hidden location, such as under the carpet, keeping it away
from any vehicle pedals or controls. Secure the excess cable with wire
ties (purchased separately).
6. Bring the end of the cable out at the PowerConnect Vehicle Dock
location. Leave yourself enough cable so you can easily connect it to
the antenna connector of the dock.
7. Continue with "Step 5: Connect the Magnetic Mount Antenna and
PowerConnect Power Adapter" on page 35.
Sedan/Coupe With Antenna Placed at the Front of the Roof
1. Feed the antenna cable from the antenna underneath the rubber
molding around the windshield. Use a blunt plastic putty knife or
similar blunt tool to lift the rubber molding around the windshield and
tuck the antenna cable underneath the molding. Route the antenna
cable around and down the windshield to the lowest point.
2. At the lowest corner of the windshield, route the cable out of the
windshield molding and into
the rubber weather stripping
around the door opening. Lift
the weather stripping from the
opening and tuck the cable
inside it, then replace the
weather stripping. Run the cable
inside of the weather stripping
to the bottom of the door
30