Bobbin Winding - Husqvarna Viking Sapphire 960Q User Manual

BOBBIN WINDING

BOBBIN WINDING THROUGH THE NEEDLE
position.
1. Place an empty bobbin on the bobbin spindle on the
bobbins.
®
2. Thread the machine with the main spool pin in the
horizontal position.
Note: If the thread spool is too large to be in horizontal
position, wind the bobbin as described under "Winding Specialty
Threads" below.
foot and up to the right through
Note: Use a metal presser foot when bobbin winding from the
needle.
4. Guide the thread through the hole in the bobbin from
the inside to the outside.
5. Push the bobbin winder spindle to the right to wind.
pressing the foot control or touch the start/stop.
When the bobbin is full, it will stop winding. Release
the foot control or touch the start/stop button to stop
bobbin winder spindle to the left and the pop-up will
close.
bobbin thread cutter.
Note: It is important that you cut the thread end close to the
bobbin.
Note: Moving the bobbin spindle to the left will engage the
sewing mechanism. Always stop winding by pushing the Start/
Stop button or releasing the foot control before moving the bobbin
spindle.
WINDING SPECIALTY THREADS
We do not recommend winding speciality threads such as
threads through the needle.
1. Place an empty bobbin on the bobbin spindle at the
® bobbins.
2. Place the large spool cap and a felt pad under the
Pre-Tension Thread guide
A
Note: When using earlier version of HUSQVARNA VIKING
bobbins that do not have a hole, wind several turns of thread on the
bobbin to get started.
B
C
®
D
S U 2:7
ET P