Table of Contents
Advertisement
Recalling the reverb setup from the Memory Stick
1
On the SETUP display, turn the jog dial to highlight "Load."
2
Press the F4 key.
The memory list is displayed.
Eject CD/MS
Rev mode
Direct/Rev : CH1-2 D+REV CH3-4 D+Rev
Load
Save
SETUP
3
Select the desired memory number 08 to 99 using the jog dial, and
press the F4 key.
The data stored in the selected memory number is loaded from the
Memory Stick.
If "Please change CDROM/MS" is displayed
2
Mono D+Rev
I 48
[Medium Hall B] PreDelay
REVERB
This message appears on the REVERB display if the setup you recalled
from the Memory Stick is the one for the reverb program of another CD
ROM. Together with the message, the F2 key flashes.
If "Please change CDROM/MS" appears, proceed as follows:
1
Press the F2 key.
The CD tray opens.
2
Replace the CD ROM with that indicated on the display and insert the
Memory Stick supplied with that CD ROM.
You need not change the Memory Stick when changing to the CD
ROM supplied with this unit if the Memory Stick currently in use is the
one supplied with the DASK-S70x series software (optional).
3
Press the F2 key again.
The CD tray closes and the reverb program is loaded from the CD
ROM.
Note
The Z key does not function after the program has been started from a CD
ROM. Use the Z key when inserting a CD ROM immediately after the
power is turned on.
[08][Test Rev #1
[09][
: Mono(1)in Stereo out
[10][
[11][
:
[12][
:
Exit
Enter
Name of the CD ROM to be changed
D A S K - S 7 0 1
[1:C12
] [ 0.00ms] [
]
]
]
]
]
O
O
RevTime
0.0s]
35
Chapter 3 Operation
Hide quick links:
Advertisement
Table of Contents
