Sony DRE-S777 Operating Instructions Manual page 23

Loading the reverb program from the cache memory
To change to another reverb program
Turn the jog dial while the F2 key is lit in green to display another reverb
program. Then press the F2 key. The selected reverb program is loaded
from the CD ROM.
When "Rev mode" is set to "Split in 4ch out" on the SETUP
display
You can select different reverb programs for both CH1-2 and CH3-4.
Make sure that the F2, F3 and F4 keys are not lit, and turn the jog dial to
display "Split CH1-2" or "Split CH3-4" on the bottom left of the reverb
source graphic. Then, press the F2 key until the desired reverb program is
displayed.
The delay time and reverb time can also be adjusted for both CH1-2 and
CH3-4.
You can store the reverb program loaded from the CD ROM in one of the
9 cache memories. Up to 9 programs can be stored and you can switch
from one to another quickly. The content of the cache memory is retained
until the power is turned off. To load the reverb program from the cache
memory, proceed as follows:
1
Press the F1 key to show the REVERB display.
1
Mono D+Rev
I 48
[Medium Hall A] PreDelay
REVERB [1:C12
2
If the F2, F3 or F4 key is lit or flashing, press the key to turn it off.
3
Turn the jog dial until the desired cache memory number (1 to 9) is
displayed.
The reverb program stored in the selected cache memory is loaded
instantly.
Cache memory number
2
Mono D+Rev
I 48 [Medium Hall B] PreDelay
REVERB [1:C12
Note
If no reverb source graphic (e.g., a hall) is displayed, no reverb program is
stored to the cache memory you selected. No sound is reproduced with
such a cache memory.
To load a reverb program from the CD ROM to an empty cache memory, see
"Loading a reverb program from the CD ROM to the selected cache memory" on
page 24.
O O
RevTime
] [ 0.00ms] [ 2.4s]
O O
RevTime
] [ 0.00ms] [ 0.0s]
Chapter 3 Operation
(continued)
23