Millivolt Appliance Checkout; Small Area Paint Touch-Up - Lennox Hearth Products CI1500DVF Care And Operation Instructions Manual

a. Unpackage and divide the fine ember material (mineral wool) into
dime-sized fluffy pieces.
b. Distribute the ember pieces over the top of the front burner ports.
Avoid covering the slots and filling the area in front of the forward
logs (see Figures 17 and 18).
Embers
Figure 17
DO NOT PLACE EMBERS ON TOP
Figure 18
OF THE BURNER SLOTS.
SIT MILLIVOLT APPLIANCE CHECKOUT
The pilot flame should be steady, not lifting or floating. Flame should
be blue in color with traces of orange at the outer edge. The top 3/8"
(10 mm) at the pilot generator (thermopile) and the top 1/8" minimum
(tip) of the quick drop out thermocouple should be engulfed in the
pilot flame. The flame should project 1" (25 mm) beyond the hood at
all three ports (Figure 19).
Replace logs if removed for pilot inspection.
To light the burner, rotate the gas valve control knob counterclockwise
to the "ON" position then turn "ON" the on/off rocker switch.
14
Figure 19 - Proper Pilot Flame Appearance
With proper care and maintenance, your appliance will provide many
years of enjoyment. If you should experience any problem, first refer to
the troubleshooting guide in this manual. If problem persists, contact
your Lennox Hearth Products Dealer.

SMALL AREA PAINT TOUCH-UP

SMALL AREA PAINT TOUCH-UP
Models with Black Painted Finish
The stove body is painted with a quality high-temperature stove paint.
Only use factory supplied Stove Paint for touch-ups (70K99).
Using one small piece of 320 grit sand paper and lightly sand the blemish so
that the edges are "feathered" or smooth to the touch between the painted
and bare sur-faces. Do not let the sand paper gum up with paint, as this
will cause scratches on the metal surface. If there are any scratches, use
600 grit sandpaper instead. Mask off surfaces you do not want painted.
Paint lightly over the bare surface first as this will act as an under-coat.
Then paint over a larger area in smooth even strokes to blend.
See Burn-In Period on Page 5 for information on curing the paint.
SMALL AREA TOUCH-UP PAINT
Models with Enamel Finish
If the enamel finish on your stove becomes chipped, it can be touched
up using the enamel touch-up paint. Follow instructions on tube for
applying. See Page 17 for ordering information.
Note: When enamel is heated to high temperatures it is subject to crazing
(a very fine and random network of hairline cracks on the surface of the
porcelain). Crazing is a normal occurrence when enamel is exposed to
high temperatures. Your enamel finish will not be harmed nor will the
function of the stove be impaired.
NOTE: DIAGRAMS AND ILLUSTRATIONS ARE NOT TO SCALE.
MILLIVOLT Hood Igniter Rod
Thermocouple
Pilot
Nozzels
Thermopile
3/8" Min.
(9 mm)