Burner Adjustments; Flame Appearance And Sooting - Lennox Hearth Products CI1500DVF Care And Operation Instructions Manual

der the bottom front of the front glass enclosure and pull
3. Reach un
it forward as shown in Figure 5.
Figure 5
4. Lift glass assembly up and out and carefully set aside in a safe
place (see Figure 6).
Figure 6
10
To install the front glass enclosure panel, proceed as follows:
1. Retrieve the glass door frame. Visually inspect the gasket on the
backside of the panel. The gasket surface must be clean, free of
irregularities and seated firmly.
2. With the stove top off, position the glass front enclosure panel into
the front opening with the gasket facing the relief door (see Figure 6).
Let the bottom of the door frame gently slide down, then hook the top
flange of the glass frame over the top of the firebox frame.
3. Fasten the two latches located beneath the firebox bottom to the glass
frame vee-flange. Close both the latches securely.
4. Reinstall the cast iron stove top (read "Caution," on this page).
5. Reinstall Trivet.

BURNER ADJUSTMENTS

The following paragraphs address burner adjustment concerns and
procedures.

Flame Appearance and Sooting:

Generally most people prefer the warm glow of a yellow to orange
flame. Appliances operated with air shutter openings that are too large
will exhibit flames that are blue and transparent. These weak, blue and
transparent flames are termed anemic. If the air shutter opening is too
small sooting may develop.
Figure 7 - Burner Flame Appearance
NOTE: DIAGRAMS AND ILLUSTRATIONS ARE NOT TO SCALE.