Devolo dLAN Manual page 20

HDMI
The HDMI cable supplied is used to connect the HDMI
socket on the dLAN TV SAT to IP Receiver to your TV
set.
Ethernet
Use the included network cable to connect the LAN
socket of the dLAN TV SAT to IP Receiver and dLAN
adapter to the network.
USB port
An external USB hard drive can be connected here for
saving TV programmes you want to view later.
Please note the following when con-
necting an external USB hard drive:
b
The first time a hard drive is inserted, the auto-
matic hard drive check may cause a delayed sys-
tem start of the dLAN TV SAT to IP Receiver. This
may take a few minutes.
b
Avoid inserting and removing USB devices in
quick succession. This may damage the USB
device. Do not remove the USB device while a file
is being played back or recorded.
b
Also note the following if a high-capacity
drive is used:
dLAN TV SAT to IP Receiver can identify a high-
capacity drive correctly and without errors, wait
about 30 seconds after connecting the two
devices
dLAN TV SAT to IP Receiver on again.
If you have not already done so, you
can go in the menu 4.4.4 Recording con-
figuration and format the detected
drive
dLAN TV SAT to IP Receiver to initial-
ise it for recording. Drives intended for
initialisation on a PC can be formatted
to FAT32 using one of the freeware
tools available on the Web. If the hard
drive is formatted in NTFS, only play-
back functions are available.
SCART (TV)
A SCART cable is used to connect the SCART output on
the dLAN TV SAT to IP Receiver to your TV set.
DIGITAL AUDIO OUT (OPT./TOSLINK)
You connect the digital audio output on the
dLAN TV SAT to IP Receiver to the corresponding elec-
trical S/PDIF input on an amplifier.
so that the
Initial use 19
before switching the
using the
devolo dLAN TV SAT Receiver Kit