Panasonic S-26PU1U6 Operating Instructions Manual page 23

163011_SingleSplit_EN_2.fm Page 23 Thursday, September 15, 2011 9:03 AM
Adjusting Wind Direction
• Never try to manually move the flap (up-down wind direction plate) that is operated by the remote controller.
• When the unit stops, the flap (up-down wind direction plate) automatically faces downwards.
• When the unit is in heating standby, the flap (up-down wind direction plate) faces upward.
Also, bear in mind that the flap starts swinging after the heating standby mode is released, but the display on the remote controller
indicates Auto Flap during standby heating as well.
CZ-RWSU1U/CZ-RWSK1U
Setting Wind Direction
While the unit is operating, every time you press
faces changes.
Setting Flap to Swing
If you press to set the flap (up-down wind direction plate) in its most
downward facing position, and then press
the flap swings automatically up and down.
Stopping Flap Swing
If you press again while the flap is swinging, you can stop the flap from
swinging and set it in place as desired. Thereafter, if you press
set the wind direction starting from the most upward position.
When the unit is in the Cool or Dry modes, the flap cannot stop facing
downwards. If you try to stop the flap from swinging while it is facing
downwards, it will continue moving until it is in the third position from the top.
CZ-RWSC1U
The available functions differ depending on the indoor unit being used.
The wind direction cannot be set via remote controller for any models other than those noted below.
Operating Multiple In/Outdoor Units Simultaneously (Group Control)
Group control works well for providing air conditioning to
one, large room with more than one air conditioning units.
• One remote controller can operate up to eight indoor units.
• All the indoor units have identical settings.
• Set temperature sensing to the indoor unit (Main Sensor).
, the direction the flap
again, is displayed and
, you can
Receiver
In the Heat Mode
Please face the flap (up-down wind
direction plate) downwards. If it faces
upwards, the warm air will not reach
the floor level.
Initial Setting
In the Cool and Dry Modes
Pleaseface the flap (up-down wind
direction plate) upwards.If the plate
faces downwards, condensation
may form and drip from around
Initial Setting
the air outlet.
In the Fan Mode In All Modes
Initial Setting
Moves Constantly
Displays with Swing Stopped
Fan/Heat Modes
Cool/Dry Modes
Indoor Unit
Indoor Unit
Signal Line
Wireless Remote Controller
23