Panasonic S-26PU1U6 Operating Instructions Manual page 14

163011_SingleSplit_EN_2.fm Page 14 Thursday, September 15, 2011 9:03 AM
UNIT DISPLAY AND OPERATION CONTROLLER FOR K1, U1, AND T1 TYPES (CONTINUED)
To access operation
controller:
ON/OFF operation button
SWEEP button
Switch
ADDRESS switch
SERVICING switches
ON. position Normal position
OFF position Select this position when the unit will not be
used for a long period of time.
TEST position
Select this position to operate the unit
continuously. This position should not be
selected under normal conditions.
14
Press on the two latches of the air intake grille with your thumb in the direction of the arrow to open
the grille. And open the air intake grille downward. The Operation Controller is located in front of the
electrical component box.
SERVICING
switches
This button is for turning the air conditioner on and off (automatically setting cooling or heating
operation).
Use this button to make the airflow direction sweep up and down automatically.
Usually set this switch in to the left side.
When operating the air conditioner by using the wireless remote controller, be sure to match the
number on this switch with the number set on the wireless remote controller.
Otherwise, the remote controller will not work.
These switches are used only when servicing the air conditioner.
Do not use these SERVICING switches for normal operation.
Turning off the ON/OFF operation button does not disconnect the power. Use the main
power switch to turn off the power completely.
ADDRESS Switch SWEEP
switch button
ON/OFF
operation
button