Rechargeable Battery - Sony HDR-CX560V Operating Manual

LCD screen
Do not exert excessive pressure on the LCD

screen, as it may cause uneven color and other
damage.
If your camcorder is used in a cold place, a

residual image may appear on the LCD screen.
This is not a malfunction.
While using your camcorder, the back of

the LCD screen may heat up. This is not a
malfunction.
To clean the LCD screen
If fingerprints or dust make the LCD screen

dirty, it is recommended that you use a soft
cloth to clean it.
On adjustment of the touch panel
([Calibration])
The buttons on the touch panel may not work
correctly. If this happens, follow the procedure
below. It is recommended that you connect your
camcorder to the wall outlet (wall socket) using
the supplied AC Adaptor during the operation.
 (MENU)  [Setup]  [
Settings)]  [Calibration].
 Touch "" displayed on the screen with the
corner of memory card or the like 3 times.
Touch [Cancel] to cancel calibration.

Notes
If you did not press the right spot, try the

calibration again.
Do not use a sharp-pointed object for

calibration. Doing so may damage the LCD
screen.
You cannot calibrate the LCD screen if it is

rotated, or closed with the screen facing out.
On handling the casing
If the casing is soiled, clean the camcorder body

with a soft cloth lightly moistened with water,
and then wipe the casing with a dry soft cloth.
Avoid the following to avoid damage to the

finish:
Using chemicals such as thinner, benzine,

alcohol, chemical cloths, repellent, insecticide
and sunscreen
Handling the camcorder with above

substances on your hands
Leaving the casing in contact with rubber or

vinyl objects for a long period of time
About care and storage of the lens
Wipe the surface of the lens clean with a soft

cloth in the following instances:
When there are fingerprints on the lens

surface
In hot or humid locations

When the lens is exposed to salty air such as

at the seaside
Store in a well-ventilated location subject to

little dirt or dust.
(General
To prevent mold, periodically clean the lens as

described above.
On charging the pre-installed

rechargeable battery

Your camcorder has a pre-installed rechargeable
battery to retain the date, time, and other settings
even when the LCD screen is closed. The pre-
installed rechargeable battery is always charged
while your camcorder is connected to the wall
outlet (wall socket) via the AC Adaptor or while
the battery pack is attached. The rechargeable
battery will be fully discharged in about 3 months
if you do not use your camcorder at all. Use
your camcorder after charging the pre-installed
rechargeable battery.
However, even if the pre-installed rechargeable
battery is not charged, the camcorder operation
will not be affected as long as you are not
recording the date.
US
117